更多"[单选题]When did the ON BAT light on t"的相关试题:
[单选题]When did TAT heating?
A. In flight, not on ground
B. On ground, not in flight
C. Only on ice condition
[单选题]When did the STROBE work?
A. After aircraft liftoff, turn to AUTO position
B. Turn to ON position
C. Both correct
[单选题]When did the rain repellent bottle should be replaced?
A. RAIN RPLNT pressure indicator, when the needle is in the yellow sector the bottle should be replaced.
B. RAIN RPLNT quantity indicator, when the REFILL float is in view the bottle should be replaced
C. Both correct
[单选题] When did they agree to pay the next service payment?
A. At the end of the month.
B. Within one month.
C. When they were happy with the plans to improve the property.
D. The agent would tell them.
[单选题]When did APU N becomes amber on the ECAM?
A. N ≥99%
B. N ≥102%
C. N ≥107%
[单选题]To perform AIR COND OFF takeoff, when did the AIR COND 2 ON?
A. 1500ft AGL
B. After climb reduced thrust
C. After flap retracted
[单选题]When did they agree to pay the next service payment?
A.At the end of the month.
B.Within one month.
C.When they were happy with the plans to improve the property.
D.The agent would tell them.
[单选题]If BAT pb is at AUTO, when will battery be charged and when will the charging cycle end?.
A. Battery voltage below 26.5 V (battery charge). The charging cycle ends when battery charge current goes below 4
B. Battery voltage below 26.5 V (battery charge). The charging cycle ends when battery charge current goes below 2 A.
C. Battery voltage below 25.5 V (battery charge). The charging cycle ends when battery charge current goes below 4 A.
[单选题]When the “RECALL” pb on ECAM control panel is pressed,
A. warning is inhibited
B. status page appears
C. the cleared warning message reappears
[单选题]To the GPWS panel on the overhead panel, there are two pushbuttons about flap, which is correct?
A. A. FLAP MODE pushbutton at OFF position, to avoid nuisance warning in case of landing with flaps setting reduced
B. B. LDG FLAP 3 pushbutton at ON position, to avoid nuisance warning in case of landing in CONF 3
C. C. Both correct
[单选题]When happens when CAPT3 is selected?
A. Pilot uses the observer’s audio equipments
B. Observer uses pilot’s audio equipments
C. Pilot uses third occupant’s ACP
[单选题]TILT knob on the weather radar panel controls the antenna tilt, which is correct?
A. A. Radar 1 depends on ADIRS 1, ADIRS 3 replaces ADIRS 1 if ATT HDG selector is set to CAPT 3
B. B. Zero represents the horizon, as seen by the ADIRS
C. C. Both correct
[单选题]PWS toggle switch on the weather radar panel at AUTO position, activates the predictive windshear function, which is correct?
A. A. Even if the SYS switch is set to OFF, windshear function is available (depend on the setting of ATC panel)
B. B. Windshear areas are detected by antenna scanning below 2 300ft RA. They are displayed on the ND, if below 1 500ft
C. C. Both correct
[单选题]The yellow system ground service panel is located on the of the fuselage.
A. left side
B. right side
C. below the cargo door
[单选题]Which Radio Management Panel(RMP) could control VHF1 transceiver?
A. RMP1
B. RMP1 and RMP2
C. RMP1,RMP2 and RMP3
[单选题]Cockpit door panel, once the button has been moved to LOCK position, the door is locked, which is correct?
A. Emergency access, the buzzer, and the keypad are inhibited for a preselected time (5 to 20 min) (AIRCRAFT SYSTEM DSC-25-11-20)
B. If the LOCK position has not been used by the pilot, for at least 5 to 20 min, the cabin crew is able to request emergency access to open the cockpit door
C. Both correct
[单选题]When RAM AIR is at ON position, when use automatic control operation and differential pressure is lower than 1 psi, the outflow valve is to
A.100%
B.80%
C.50%