更多"A governor automatically controls e"的相关试题:
[单项选择]On most diesel engines, the governor controls the output speed by （）.
A. controlling the amount of fuel injected into the cylinders
B. varying the speed of the turbocharger
C. adjusting the compression ratio
D. changing the timing of the fuel injection camshaft
[单项选择]A change in engine speed is required before a governor is able to make a corrective movement of fuel rackThis aspect of governing is commonly expressed as a percent and is known as （）
A. governor sensitivity
B. governor promptness
C. speed droop
D. isochronous governing
[单项选择]The hydraulic （） is used to control engine speed.
A. motor
B. pump
C. governor
D. capstan
[单项选择]Defective governor in a diesel engine may lead to （）.
A. smoky exhaust
B. starting failure
C. ignition relay
D. over speed
[单项选择]An overcorrecting and unstable engine governor operation is known as（）.
A. droop
B. dead banding
C. dash potting
D. hunting
[单项选择]The governor of a generator engine is to （）.
A. make the engine stop
B. regulate the timing of camshafts
C. make the rpm stabilize at any required value
D. make the engine run at nearly constant speed
[单项选择]On a diesel engine equipped with a hydraulic speed control governor, hunting in many cases can be corrected by adjusting the （）
A. accumulator spring compressor
B. balance piston
C. compensating needle valve
D. proportional piston
[单项选择]“The engine not obtaining the sufficient speed for firing” means that （）.
A. the start fails
B. the fuel pumps will be put into operation
C. the fuel valves are damaged
D. the combustion process will take over
[单项选择]A diesel engine experiences a sudden loss in speed, accompanied by black exhaust smoke, with the fuel rack at maximum, and speed remaining below normal the probable（）
A. engine overload
B. leaky valves
C. stuck or broken piston rings
D. low air injection pressure
[单项选择]A diesel engine is turned at normal cranking speed and no ignition occursThis could be the result of （）
A. low lube oil temperature
B. low starting air temperature
C. air bubbles in the fuel oil system
D. water in the starting air system
[单项选择]The minimum speed an engine must attain before ignition can occur depends upon （）.
A. the type and size of the engine
B. the condition of the engine
C. ambient temperature
D. all of the above
[单项选择]The rotating range of the low speed diesel engine is usually lower than （）.
A. 100 rpm
B. 200 rpm
C. 300 rpm
D. 500 rpm
[单项选择]The term medium speed diesel engine is currently taken to mean an engine with an operating rotational speed of （） rpm.
A. below 300
B. above 1200
C. between 300 to 1200
D. below 1200
[单项选择]As engine RPM is increased from idle speed to full load speed, which of the conditions listed will decrease?（）
A. Compression ratio
B. Fuel/Air ratio
C. Compression pressure
D. Lube oil pressure
[单项选择]On a large low-speed main propulsion diesel engine, lower main bearing wear is usually measured by using a/an （）
A. dial indicator
B. outside caliper
C. bridge gauge
D. tram rod
[单项选择]If the speed of a turbocharged diesel engine is maintained constant the turbocharger speed will （）
A. decrease until the engine speed increases
B. increase as the load increases
C. decrease as the load
D. increases remain unchanged
[单项选择]In a large, low-speed diesel engine the clearance between the piston crown and cylinder head is found to be excessiveIn order to correct for this, you should（）
A. build up the piston crown by metal spraying
B. build up the cylinder head by metal spraying
C. insert shims between the crankpin bearing box and the connecting rod foot
D. install a thinner head gasket
[单项选择]
In a medium speed diesel engine, a trunk type piston may be cooled by（）
Ⅰ.oil circulation though passages in the piston crown
Ⅱ.heat transfer through piston rings and liner wall
A. Ⅰ only
B. Ⅱ only
C. either Ⅰ or Ⅱ
D. neither Ⅰ or Ⅱ
