更多"Cooling enables the engine metals ("的相关试题:
[单项选择]Cooling makes the engine metals their mechanical properties().
A. Remain
B. to remain
C. retain
D. to retain
[单项选择]Cooling () the engine metals retain their mechanical properties.
A. forces
B. enables
C. makes
D. is able to
[单项选择]Cooling of engine is achieved by circulation a cooling liquid around internal passages within the ().
A. boiler
B. heater
C. engine
D. cooler
[单项选择]Improper cooling of a diesel engine cylinder liner due to the accumulation of scale deposits may cause ().
A. low compression pressure
B. increased piston wear
C. increased cylinder lube oil consumption
D. poor contact between compression rings and liner
[单项选择]After-cooling of a turbocharged diesel engine will result in ()
A. higher torque but lower brake horsepower
B. lower torque but higher brake horsepower
C. higher torque and lower brake horsepower
D. lower torque and higher brake horsepower
[单项选择]Why the cooling water of the diesel engine should be treated? Because the()
A. Cooling water is alkalescence
B. cooling water is acidity
C. cooling water has salinity
D. cooling water has impurity
[单项选择]The cooling water of the diesel engine should be treated, because it has()
A. alkale scence
B. acidity
C. salinity
D. impurity
[单项选择]High diesel engine cooling water temperatures can be caused by ().
A. a worn water pump
B. not enough coolant
C. air in the cooling system
D. all of the above
[单项选择]In a closed diesel engine freshwater cooling system, the amount of coolant flowing through the heat exchanger is controlled by the ().
A. suction pressure regulator
B. thermostatic bypass valve
C. sea water temperature
D. water level in the expansion tank
[单项选择]For diesel engine piston cooling, lubricating oil can be supplied to the pistons by a/an ().
A. oil spray
B. oil bath
C. oil control rings
D. drilled passage through the camshaft
[单项选择]In any diesel engine closed freshwater cooling system, the lowest pressure exists at the ().
A. jacket water outlet
B. cooling water pump outlet
C. heat exchanger outlet
D. expansion tank atmospheric vent
[单项选择]Cooling the intake air supplied to a diesel engine will ().
A. reduce mean effective pressure
B. decrease average compression pressure
C. decrease air charge density
D. increase power output
[单项选择]A diesel engine cooling water system with a pH factor of 30 indicates a condition of ().
A. slight acidity
B. slight alkalinity
C. excessive alkalinity
D. excessive acidity
[单项选择]In a diesel engine cooling system, the high temperature alarm contact maker will be activated on excessively high water discharge temperature from the ()
A. raw water pump discharge
B. expansion tank outlet
C. cooling water heat exchanger
D. outlet engine jacket water outlet
[单项选择]In a diesel engine exhaust system, the cooling of the exhaust gases below their dew point, will result in ()
A. increased engine back pressure
B. sulfuric acid corrosion
C. surface pitting of the turbocharger
D. moisture impingement on the turbocharger compressor blade
[单项选择]In a diesel engine cooling water system, a pH of 60 indicates a/an ().
A. slightly acidic condition
B. slightly alkaline condition
C. overtreatment of water
D. neutral condition of water
[单项选择]Modern marine diesel engines equipped with mechanical fuel injection operate on a combustion phase within the cycle which is()
A. entirely constant pressure
B. entirely constant temperature
C. a combination of constant volume and constant pressure
D. a combination of constant temperature and constant pressure
[单项选择]
Which of the following are components of a mechanical seal? ()
(1) stationary ring
(2) rotational ring
(3) packing
(4)spring
A. (1), (2) and (3)
B. (1), (2) and (4)
C. (2), (3) and (4)
D. None of the above