更多"Which of the following would be con"的相关试题:
[单项选择]Which of the following topology situations would be a qood candidate for configuring DMVPN（）
A. Extranet VPN
B. Managed overlay VPN topology
C. Hub-and-spoke VPN topology
D. Central-site VPN topology
E. Full mesh VPN topology
F. Remote-access VPN topology
[单项选择]Which of the following electric motors would be the safest and most reliable to use on the main deck of a vessel in foul weather conditions?（）
A. Sealed motors
B. Drip proof motors
C. Enclosed motors
D. Watertight motors
[多项选择]Which of the following IP hosts would be valid for PC users, assuming that a /27 network mask was used for all of the networks?（）
A. 15.234.118.63
B. 83.121.178.93
C. 134.178.18.56
D. 192.168.19.37
E. 201.45.116.159
F. 217.63.12.192
[单项选择]Which of the following commands would successfully implement an access list on a routers virtual terminal line?（）
A. RouterTK(config-line)# access-class 10 in
B. RouterTK(config-if)# ip access-class 23 out
C. RouterTK(config-line)# access-list 150 in
D. RouterTK(config-if)# ip access-list 128 out
E. RouterTK(config-line)# access-group 15 out
F. RouterTK(config-if)# ip access-group 110 in
[单项选择]Which of the following conditions would cause carbon deposits to form in the piston ring belt of a diesel engine?（）
A. faulty combustion
B. excessive ring temperature
C. over lubrication
D. all of the above
[单项选择]At which of the following locations would a duplex pressure gage most likely be located?（）
A. Fuel oil service pump discharge
B. Fuel oil strainer
C. Fuel oil heater
D. Fuel oil flow meter
[单项选择]Which of the following problems would be the probable cause for the faulty operation of a reciprocating air compressor suction valve?（）
A. Carbon build up in the piston ring belt
B. Faulty operation of a cylinder un-loader
C. Compressor operation in an area of high relative humidity
D. Lifting of intercooler rebel valve
[单项选择]Which of the following faults would allow lube oil to enter the cooling system of a diesel engine?（）
A. Excessive valve train lubrication
B. Leaking standby oil cooler core
C. Excessive lube oil pressure
D. Excessive lube oil in the system
[单项选择]Which of the following terms would best describe the temperature at which a liquid boils at a given pressure?（）
A. Degree of saturation
B. Saturation temperature
C. Superheated temperature
D. Degree of superheat
[单项选择]Which of the following commands would you use, to configure a default route to any destination NOT found in the routing table?（）
A. Router(config)# ip default-route 0.0.0.0 255.255.255.255 s0
B. Router(config)# ip route 0.0.0.0 255.255.255.255 s0
C. Router(config)# ip default-route 0.0.0.0 0.0.0.0 s0
D. Router(config)# ip route 0.0.0.0 0.0.0.0 s0
E. Router(config)# ip route any any e0
[单项选择]Which of the following would be of immediate concern after discovering a large fire in the ship’s galley?（）
A. An adjacent storeroom，containing spare parts
B. A storeroom directly above，containing combustible fluids
C. An adjacent storeroom，containing mattresses and linen
D. An adjacent storeroom，marked "Stewards Stores"
[单项选择]Which VPN management feature would be considered to ensure that the network had the least disruption of service when making topology changes?（）
A. dynamic reconfiguration
B. path MTU discovery
C. auto setup
D. remote management
[单项选择]Which of the listed materials would be considered as a bunting class "C" fire?（）
A. Fuel oil
B. Wood
C. Celluloid
D. Electrical insulation
[单项选择]Which of the following would not cause high suction pressure?（）
A. insufficient refrigeration
B. leaky suction valves
C. expansion valve stuck open
D. suction valve not adjusted properly
[单项选择]Which of the following would cause a diesel to have black smoke?（）
A. leaky injector
B. water in the gas
C. too heavy oil
D. water in the oil
[单项选择]Which of the following is not considered a common approach to narrow the field of potential problem causes（）
A. Following the traffic path
B. Top-down
C. Comparing configurations
D. Bottom-up
E. Divide and conquer
F. ExamineS LAs
[单项选择]While underway, which of the following would be the FIRST step in reversing a direct reversing large, low-speed, main propulsion, diesel engine?（）
A. Manually trip the over-speed device
B. Interrupt the fuel flow to the engine
C. Disengage the safety interlock
D. Slide the camshaft to the neutral position
