更多"The rate of heat transfer between t"的相关试题:
[单项选择]The rate of heat transfer from a hot region to a cold region is affected most by the （）.
A. size of the heat sink
B. temperature difference between the regions
C. size of the heat source
D. total heat of the system
[单项选择]The rate of heat transfer in a water-tube auxiliary boiler can be increased by （）.
A. operating the boiler at less than normal water level
B. installing fins on the firesides of water-tubes
C. increasing the amount of excess air to the burners
D. treating the boiler water with chemical oxygen scavengers
[单项选择]Data transfer is slow between the source and destination. The quality of service requested by the transport layer in the OSI reference model is not being maintaineD.To fix this issue, at which layer should the troubleshooting process begin?（）
A. presentation
B. session
C. transport
D. network
E. physical
[单项选择]In extreme weather conditions, either hot or cold, control of the air conditioning plant presents （） difficulties.
A. few
B. little
C. a little
D. less
[单项选择]The sum of the sensible heat and the latent heat of any substance is known as （）.
A. total heat
B. residual heat
C. specific heat
D. superheat
[单项选择]Hot gas defrosting uses the hot gas from （） to defrost the evaporator.
A. starting air bottles
B. diesel engines
C. boilers
D. refrigeration compressors
[单项选择]After a cold front passes the barometric pressure usually（）.
A. fluctuates
B. remains the same
C. remains the same，with clouds forming rapidly
D. rises，often quite rapidly，with clearing skies
[单项选择]Diesel engine starting difficulties due to cold intake air temperatures, can be overcome by using a/an（）
A. increase in starting air pressure
B. increase in lube oil viscosity
C. compression expansion device
D. jacket water heater
[单项选择]Cold water flowing southward through the western part of the Bering Strait between Alaska and Siberia is joined by water circulating counterclockwise in the Bering Sea to form the（）.
A. Alaska Current
B. Subarctic Current
C. Kuroshio Current
D. Oyashio Current
[单项选择]Scale accumulation on evaporator heat exchange surfaces （）.
A. increases brine density
B. increases distillate salinity
C. reduces metal corrosion
D. reduces heat transfer
[单项选择]Additional heat extraction from the exhaust gases can be effected by adding an （） section to the unit in plants.
A. air cooler
B. economizer
C. injector
D. air blower
[单项选择]Which statement is TRUE when comparing cold and warm fronts?（）
A. Cold fronts are more violent and of shorter duration
B. Cold fronts are milder and last longer
C. They are very similar with the exception of wind direction
D. Warm fronts are more violent and of longer duration
[单项选择]During extremely cold weather, while starting an engine, it turns too slowly and fails to startThis problem is most likely the result of （）
A. high fuel oil viscosity
B. low fuel oil temperature
C. high lube oil viscosity
D. energized glow plugs
[单项选择]Cold clearances between the skirt of an aluminum piston and the cylinder liner is about （）
A. twice as large as with a cast iron piston
B. the same size as with a cast iron piston
C. half as large as with a cast iron piston
D. the same size as the crown of an aluminum piston
[单项选择]Prior to lighting off a cold automatically fired auxiliary boiler, you should （）.
A. check and regulate the water level
B. close the air cock once fires are lit
C. blowdown the gage glass
D. crack the steam stop to assure protective steam flow
[单项选择]Symptoms of heat stroke are（）.
A. cold and moist skin，high body temperature
B. cold and dry skin，low body temperature
C. hot and moist skin，high body temperature
D. hot and dry skin，high body temperature
