更多"Compared to internal structural pla"的相关试题:
[单项选择]Compared to internal structural plating,the exterior hull plating on a vessel is usually().
A. stronger
B. thinner
C. more corrosion resistant
D. a lower grade steel
[单项选择]Compared to internal structural plating. The exterior hull plating on a vessel is usually().
A. stronger
B. thinner
C. more corrosion resistant
D. a lower grade steel
[单项选择]Shell plating is().
A. the galvanizing on steel
B. a hatch cover
C. the outer plating of a vessel
D. synonymous with decking
[单项选择]The deck plating on a ship is supported primarily by deck longitudinals and deck().
A. girders
B. stanchions
C. frames
D. beams
[单项选择]Vertical structural members attached to the floors that add strength to the floors are called().
A. boss plates
B. buckler plates
C. stiffeners
D. breast hooks
[单项选择]When riveted joints occur at the ends of plating they are called().
A. trailers
B. terminals
C. seams
D. butts
[单项选择]Support of ship side plating is provided primarily by transverse().
A. beams
B. girders
C. frames
D. bulkheads
[单项选择]Shell plating that has curvature in two directions and must be heated and hammered to shape over specially prepared forms is called().
A. compound plate
B. furnaced plate
C. flat plate
D. rolled plate
[单项选择]The central longitudinal structural hull strength member of the lower hulls of semisubmersible ship’s is called the().
A. stress plate
B. keel
C. rider plate
D. main beam
[单项选择]A term applied to the bottom shell plating in a double-bottom ship is().
A. bottom floor
B. outer bottom
C. shear plating
D. tank top
[单项选择]Which arrangement of shell plating is used most in modern shipbuilding().
A. Clinker
B. Flush
C. In-and-Out
D. Joggled
[单项选择]Where is thicker plating usually found in the construction of integral tanks on a ship? ()
A. On the outside of the tank
B. At the bottom of the tank
C. At the top of the tank
D. At the center of the tank
[单项选择]The fore and aft run of deck plating which strengthens the connection between the beams and the frames and keeps the beams square to the shell is called the().
A. garboard strake
B. limber strake
C. sheer strake
D. stringer strake
[单项选择]The heavier outboard strake of deck plating on a ship is called the deck().
A. stiffener
B. beam
C. stringer
D. doubler
[单项选择]Structural stress levels in a ship are the sum of loading stresses and stresses due to().
A. environmental loads
B. variable loads
C. ballast loading
D. mooring loads
[单项选择]The athwartship hull structural members of a ship are().
A. stringers
B. girders
C. breasthooks
D. deck beams
[单项选择]The bottom row of plating next to the keel of a lifeboat is known as the().
A. sheer strake
B. bilge strake
C. garboard strake
D. keel rib
[单项选择]A crack in the deck plating of a vessel may be temporarily prevented from increasing in length by().
A. cutting a square notch at each end of the crack
B. drilling a hole at each end of the crack
C. slot-welding the crack
D. welding a doubler over the crack