更多"No oil or mixture containing oil（）i"的相关试题:
[单项选择]No oil or mixture containing oil（）into Singapore waters from any vessel.
A. shall not be discharged
B. shall be discharged
C. shall be filled
D. shall not be filled
[单项选择]The remaining oil/water mixture now flows down into the fine separating compartment and moves slowly between the（） in the Turbulo separator.
A. catch plates
B. swash plates
C. cover plates
D. bedplates
[单项选择]Before pumping up the crankcase oil,（） should be worked by hand to minimize corrosive action on the liners.
A. the indicators
B. the starting valves
C. the cylinder lubricators
D. the turning gear
[单项选择]When discharging oil from an oil tanker the instantaneous rate（）60 liters per nautical mile.
A. Should not exceed
B. Must be up to
C. Should exceed
D. Should be about
[单项选择]Unless such oil tanker carries crude oil which is not suitable for crude oil washing，the oil tanker shall（）the system in accordance with the requirements of that Regulation.
A. operate
B. check
C. install
D. overhaul
[单项选择]Machinery driving fuel oil transfer and fuel oil service pumps must be fitted with a remote means of stopping the machinery from （）.
A. within the space concerned
B. outside the space concerned
C. the throttle station
D. within the fire room
[单项选择]
When fuel oil is accidentally missed with lube oil which of the following processes can be used to separate them?（）
Ⅰ.filtering
Ⅱ.settling
A. Ⅰ only
B. Ⅱ only
C. either Ⅰ or Ⅱ
D. neither Ⅰ or Ⅱ
[单项选择]The oil discharge monitoring system in the oil tanker vessels is used for detecting the amount of oil discharged overboard to ensure that it does not exceed（）
A. 15 liters nautical mile
B. 30 liters nautical mile
C. 60 liters nautical mile
D. 100 liters nautical mile
[单项选择]The term OIL as used in the Oil Pollution Regulations means（）.
A. fuel oil
B. sludge
C. oil refuse
D. All of the above
[单项选择]Diesel engine lube oil diluted with fuel oil is indicated by（）
A. decreased viscosity
B. decreased pour point
C. increased flash point
D. increased viscosity
[单项选择]Cylinder oil is a high viscosity mineral oil, with a （） machined to the anticipated sulfur content of the fuel.
A. TAN
B. TBN
C. SAN
D. SBN
[单项选择]When separating fuel oil in oil separator, the separating quantity is（） of the real quantity.
A. 100%
B. 80%
C. 1/2
D. 1/3
[单项选择]The lube oil cooler is located after the lube oil filter in order for （）
A. the filter to operate more efficiently
B. the lube oil cooler to be bypassed
C. positive lube oil pump suction to be assured
D. galvanic action in the cooler to be minimized
[单项选择]Oil slick caused by spillage of oil from tanker ship is（）.
A. a drop of oil
B. the emulsion of oil at sea surface
C. the weathered oil
D. the oil floating on the surface of the sea water
[单项选择]Waste oil from the lube oil sumps of machinery may NOT be （）.
A. drained into the vessels bilges
B. reclaimed for other uses
C. held in a slop tank
D. purified and then reused
[单项选择]What type of oil is not covered in the oil pollution law?（）
A. mineral oil
B. machinery oil being transferred for shipboard use
C. crude oil unrefined
D. normal bilge oil and water
[单项选择]The oil （） in the discharging water from oil water separator exceeds 15 PPM without alarm, because the coil was burnt out.
A. filter
B. hole
C. pollution
D. content
[单项选择]In an oil cooler circulated by sea water, the oil is at a larger pressure, the result being that any leak in the cooler will mean a loss of （）.
A. oil
B. sea water
C. refrigerant
D. fresh water
