更多"When does the next bus leave for Gl"的相关试题:
[单项选择]
When does auxiliary burner of rotary nozzle incinerator begin to work? （）
Ⅰ.hen igniting
Ⅱ.he sludge for dealing with is too much
Ⅲ.efore stopping incinerator
A. Ⅰ+Ⅱ
B. Ⅰ+Ⅲ
C. Ⅱ+Ⅲ
D. Ⅰ+Ⅱ+Ⅲ
[单项选择]
When does auxiliary burner of incinerator put into operation? （）
Ⅰ. start incinerator when it is cold
Ⅱ. the sludge for dealing with is little
Ⅲ. the sludge for dealing with is large
Ⅳ. the water and impurity in sludge are too much
Ⅴ. the temperature in incinerator is low
Ⅵ. dealing with little solid rubbish
A. Ⅰ+Ⅱ+Ⅲ+Ⅴ
B. Ⅰ+Ⅱ+Ⅲ+Ⅳ
C. Ⅰ+Ⅳ+Ⅴ+Ⅵ
D. Ⅰ+Ⅱ+Ⅲ+Ⅵ
[单项选择]Excuse me, does this bus go to the bookstore?（）
A. The bus is so crowded.
B. The bookstore is five blocks away.
C. No. You‘d better change at the next stop.
D. You should wait in line.
[单项选择]Regarding fast path processing, when does the system perform the policy check?（）
A. The policy is determined after the SCREEN options check.
B. The policy is determined only during the first packet path, not during fast path.
C. The policy is determined after the zone check.
D. The policy is determined after the SYN TCP flag.
[单项选择]–How long does the bus?-（）About half an hour.
A. spend
B. take
C. use
[单项选择]When does a pilot say make all lines fast ? He says it when（）.
A. the ship is very close to the pier
B. the ship is about to be in position
C. the ship is in position
D. the ship is getting alongside the pier
[单项选择]When does your father get up every morning? He（）up at six.
A. get
B. got
C. gets
D. will
[单项选择]Excuse me, when is the next flight from London due to arrive? （）
A. In half an hour.
B. An hour before.
C. Until the next one.
D. Before another one.
[单项选择]What happens when a route does not match any user configured policies?（）
A. The route is rejected.
B. The route is accepted.
C. The route is given a lower priority.
D. The route is sent to the default policy.
[单项选择]When a power supply does not meet minimum requirements for a motherboard, which of thefollowing can happen?（）
A. Computer will not POST
B. Computer will overheat
C. Monitor will not power on
D. Processor will not run at proper speed
[单项选择]What purpose does a bridge fitting serve when lashing containers?（）.
A. Ties a container stack to the deck
B. Ties a container to the container below it
C. Restrains racking loads
D. Restrains the container against horizontal motion
[单项选择]What does a BGP route reflector do when reflecting a route?（）
A. It prepends its cluster identifier to the route's cluster list.
B. It prepends its own originator identifier to the route's cluster list.
C. It replaces the route's cluster identifier with its own cluster identifier.
D. It replaces the route's originator identifier with its originator identifier.
[单项选择]When the truck does not work, the driver should（）engines.
A. turn on
B. turn off
C. shut up
D. close
[单项选择]How does a switch respond when it receives a message?（）
A. It reads the Layer-5 information and sends the message directly to the intended computer.
B. It reads the Media Access Control (MAC) address and broadcasts the message to all the computers that are connected to the switch.
C. It reads the Media Access Control (MAC) address and sends the message directly to the intended computer.
D. It reads the Layer-5 information and broadcasts the message to all the computers that are connected to the switch.
[单项选择]Which action does a BGP speaker take when it detects that the reset state bit is set in an openmessage?（）
A. It tears down the BGP session.
B. It sends a restart message to the peer.
C. It marks all routes from that peer as stale.
D. It sends a BGP refresh message to the peer
[单项选择]How does DB2 protect the integrity of indexes when data is updated?（）
A. Locks are acquired on the data.
B. Locks are acquired on index keys.
C. Locks are acquired on index pages.
D. Locks are acquired on index pointers.
[单项选择]What does the term head mean when applied to a fire pump?（）
A. Length of the discharge pipe
B. Height of the discharge pipe
C. Difference between the discharge and suction pressures
D. Sum of discharge and suction pressures
