更多"While troubleshooting a connectivit"的相关试题:
[单项选择]While troubleshooting a connectivity issue from a PC you obtain the following information: Local PC IP address: 10.0.0.35/24 Default Gateway: 10.0.0.1 Remote Sever: 10.5.75.250/24 You then conduct the following tests from the local PC: Ping 127.0.0.1 – Successful Ping 10.0.0.35 – Successful Ping 10.0.0.1 – Unsuccessful Ping 10.5.75.250 – Unsuccessful What is the underlying cause of this problem?()
A. A remote physical layer problem exists.
B. The host NIC is not functioning.
C. TCP/IP has not been correctly installed on the host.
D. A local physical layer problem exists.
[单项选择]While troubleshooting a network connectivity issue, you suspect that a router may be missing a route, or may be receiving bad routing information to a destination. What command should you issue to view the route that the router will use to reach a given destination?()
A. ping
B. trace
C. show ip route
D. show interface
E. show cdp neighbors
[多项选择] While troubleshooting connectivity issues, you log into a remote router. From there,you wish to see the layer 1 and layer 2 status of the interface. Which of the following IOS commands would you issue to check the current IP addressing, as well as theyer 1 and layer 2 status of an interface?()
A. TK1# show version
B. TK1# show protocols
C. TK1# show interfaces
D. TK1# show controllers
E. TK1# show ip interface
F. TK1# show startup-config
[单项选择]While troubleshooting a connectivity problem on the network, you issue the ping command from your PC command prompt, but the output shows "request times out."At which OSI layer is this problem associated with?()
A. The data link layer
B. The application layer
C. The access layer
D. The session layer
E. The network layer
[多项选择]While troubleshooting some connectivity issues,you issue the “show ip ospf database”in order to ex amine the link state database. Which three of the statements below are true regarding the OSPF link state database()
A. Each router has an identical link state database.
B. External routes are imported into a separate link state database.
C. Syn chronization of link state databases is maintained via floodingo f LSAs.
D. Information in the link state database is used to build a routing table by calculating a shortest-path tree.
E. By default,link state databases are refreshede very 10 minutes in the absence of topology changes.
[单项选择]While troubleshooting a connectivity problem, a network administrator notices that a port status LED on a Cisco Catalyst series switch is alternating green and amber. Which condition could this indicate()。
A. The port is experiencing errors
B. The port is administratively disabled
C. The port is blocked by spanning tree
D. The port has an active link with normal traffic activity
[单项选择]While troubleshooting a network connectivity problem, a technician observes steady link lights on both the workstation NIC and the switch port to which the workstation is connected. However, when the ping command is issued from the workstation, the output message "Request timed out." is displayed. At which layer of the OSI model does the problem most likely exist()。
A. the session layer
B. the protocol layer
C. the data link layer
D. the access layer
E. the network layer
F. the application layer
[多项选择]You are troubleshooting a routing issue and need to check the hop-by-hop path to the 10.10.10.10 destination. Which three commands would display the path?()
A. user@router# traceroute 10.10.10.10
B. user@router> ping record-route 10.10.10.10
C. user@router>traceroute 10.10.10.10
D. user@router# run traceroute 10.10.10.10
E. user@router# ping record-route 10.10.10.10
[单项选择]When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?()
A. show ip access-list
B. show access-list
C. list ip interface
D. show interface
E. show ip interface
[单项选择]When troubleshooting an EIGRP connectivity problem, you notice that two connected EIGRP routers are not becoming EIGRP neighbors. A ping between the two routers was successful.What is the next thing that should be checked?()
A. Verify that the EIGRP hello and hold timers match exactly.
B. Verify that EIGRP broadcast packets are not being dropped between the two routers with the show ip EIGRP peer command.
C. Verify that EIGRP broadcast packets are not being dropped between the two routers with the show ip EIGRP traffic command.
D. Verify that EIGRP is enabled for the appropriate networks on the local and neighboring router.
[单项选择] You are troubleshooting an issue which is causing full-sized packets entering the MPLS cloud be dropped. You have discovered that one of the switches in the MPLS core is not a Cisco switch, but otherwise the MPLS MTU size is set to 1508 bytes on the routers. Based on this information, which of these may be the reason the packets are being dropped?()
A. The switch on you MPLS core that was not produced by Cisco does not support oversized packets
B. No switches support oversized packets
C. By definition, the maximum MTU is 1500 bytes
D. As MPLS VPN labeling increases the size of the packet by 8 bytes, the IP MTU should have been changed to 1508
[多项选择] While troubleshooting an EIGRP routing problem you notice that one of the routers have generated a large number of SIA messages. What are two possible causes for EIGRP Stuck - In -Active routes?()
A. Some quer y or reply packets are lost between the routers.
B. The neighboring router starts receiving route updates from this router.
C. A failure causes traffic on a link between two neighboring routers to flow in only one direction(unidirectional link).
D. Th e neighboring router stops receiving ACK packets from this router.
[单项选择] While troubleshooting a network outage, you discover that an employee brought a switch from home into the office to connect additional equipment to the network. In order to increase his speed, he connected this switch to both network ports in his office, resulting in a bridge loop. Which of these can you implement to prevent future occurrences of this issue?()
A. RSTP
B. root guard
C. BPDU guard
D. GLBP
[多项选择]While troubleshooting a video problem on an application server, the system administrator has determined that the video firmware should be updated. Which of the following sources should be used to locate an appropriate update for this hardware?()
A. Third-party manufacturer
B. Video chipset manufacturer
C. Server manufacturer
D. Operating system manufacturer
E. Shareware file sharing site
[单项选择]While troubleshooting a network problem,a technician discovers that the current copy of the Cisco IOS is outdated and needs to be updated.Which of the following commands would the technician issue to replace the Cisco router IOS with the newer version?()
A. Router#copy tftp flash
B. Router(config)#restore flash
C. Router(config)#repair flash
D. Router#copy flash run
E. Router>copy start flash
F. Router#copy start flash