更多"the network administrator has been "的相关试题:
[多项选择]the network administrator has been asked to give reasons for moving from ipv4 to ipv6. what are two valid reasons for adopting ipv6 over ipv4?()
A. telnet access does not require a password
B. nat
C. no broadcast
D. chanage of destination address in the ipv6 header
E. chanage of source address in the ipv6 header
F. autoconfiguration
[单项选择]Your network administrator has asked you to view the real-time interface usage on ge-0/0/0, Which command whould be used?()
A. monitor interface ge0/0/0
B. traceoptions interface ge-0/0/0
C. debug interface ge0/0/0
D. monitor usage ge-0/0/0
[单项选择]The network administrator has asked you to check the status of the workstation’s IP stack by pinging the loopback address.Which address would you ping to perform this task?()
A. 10.1.1.1
B. 127.0.0.1
C. 192.168.0.1
D. 239.1.1.1
[单项选择] A network administrator has been receiving work orders about poor voice quality crossing a branch T1. The cause is determined to be users running high bandwidth file sharing applications across the T1 sending large packets delaying the smaller voice streams. Which of the following would improve voice quality?()
A. Configure traffic shaping to reduce the bandwidth available to the file sharing application.
B. Configure a separate VLAN for the IP phones.
C. Install a content caching proxy at the branch to reduce inbound WAN traffic.
D. Upgrade switches to provide higher bandwidth ports for workstations and IP phones.
[单项选择]The network administrator is asked to configure 113 point-to-point links. Which IP addressing scheme best defines the address range and subnet mask that meet the requirement and waste the fewest subnet and host addresses?()
A. 10.10.0.0/18 subnetted with mask 255.255.255.252
B. 10.10.0.0/25 subnetted with mask 255.255.255.252
C. 10.10.0.0/24 subnetted with mask 255.255.255.252
D. 10.10.0.0/23 subnetted with mask 255.255.255.252
E. 10.10.0.0/16 subnetted with mask 255.255.255.252
[单项选择]As a network administrator, you have been instructed to prevent all traffic originating on the LAN from entering the R2 router. Which the following command would implement the access list on the interface of the R2 router?()
A. access-list 101 in
B. access-list 101 out
C. ip access-group 101 in
D. ip access-group 101 out
[单项选择]The network administrator has discovered that the power supply has failed on a switch in the company LAN and that the switch has stopped functioning. It has been replaced with a Cisco Catalyst 2950 series switch.What must be done to ensure that this new switch becomes the root bridge on the network?()
A. One router is running RIPv1.
B. RIP neighbor is 224.0.0.9.
C. The network contains a loop.
D. Network 10.10.1.0 is reachable.
[多项选择]A network administrator has configured access list 172 to prevent Telnet and ICMP traffic from reaching a server with the address if 192.168.13.26. Which command can the administrator issue to verify that the access list is working properly?()
A. Router# ping 192.168.13.26
B. Router# debug access-list 172
C. Router# show open ports 192.168.13.26
D. Router# show access-list
E. Router# show ip interface
[单项选择] A network administrator has configured source NAT, translating to an address that is on a locally connected subnet.The administrator sees the translation working, but traffic does not appear to come back. What is causing the problem?()
A. The host needs to open the telnet port.
B. The host needs a route for the translated address.
C. The administrator must use a proxy-arp policy for the translated address.
D. The administrator must use a security policy, which will allow communication between the zones.