更多"In a point-to point network, which "的相关试题:
[单项选择]Under which network type circumstance would an OSPF router establish router adjacencies while not performing the DR/BDR election process?（）
A. Point-to-point
B. Broadcast
C. Non-broadcast multi-access
D. Backbone area 0
E. None of the above
[单项选择]A Class C network address has been subnetted with a /27 mask.Which of the following addresses is a broadcast address for one of the resulting subnets?（）
A. 201.57.78.33
B. 201.57.78.64
C. 201.57.78.97
D. 201.56.78.97
E. 201.57.78.159
F. 201.57.78.254
[单项选择]In any NAT (network address translation) configuration, what is the Inside Global IP address?（）
A. The summarized address for all internal subnetted addresses.
B. A private IP address assigned to a host on the inside network.
C. A registered address that represents an inside host to an outside network.
D. A unique IP address used on an internal network
E. Non of the above
[单项选择]What is the network address for a host with the IP address 201.100.5.68/28?（）
A. 201.100.5.0
B. 201.100.5.32
C. 201.100.5.64
D. 201.100.5.65
E. 201.100.5.31
F. 201.100.5.1
[单项选择]What is the network address for the 10.13.147.100/19 host?（）
A. 10.13.128.0
B. 10.13.147.0
C. 10.13.0.0
D. 10.13.100.0
[单项选择]A SONET network typically uses which of the following transmission media?（）
A. Single-mode fiber
B. Multimode fiber
C. Copper
D. Wireless
[单项选择]About the following IP address ,Which is incorrect
A. 202.115.258.11
B. 127.0.0.1
C. 202.115.199.199
D. 203.115.26.0
[单项选择]You are the Cisco Network Designer. Which of these is least important when determining how many users a NAS can support?（）
A. bandwidth
B. number of plug-ins per scan
C. total number of network devices
D. number of checks in each posture assessment
[单项选择]You are the Cisco Network Designer . Which is not major scaling, sizing, and performance consideration for an IPsec design?（）
A. connection speed
B. number of remote sites
C. features to be supported
D. types of devices at the remote site
[单项选择]所谓的NAT（Network Address Translation）技术，就是指在一个网络内部，根据需要不经申请自定义（）。
A. IP地址
B. 物理地址
C. 网络层
D. 数据链路层
[单项选择]On a network switch, which of the following is the default native VLAN?（）
A. 0
B. 1
C. 1024
D. 4096
[单项选择]A network IPS provides which of the following?（）
A. The layer 3 protocol on which other protocols like TCP and UDP communicate.
B. Enables the IPSec protocol on internal workstations.
C. Packet-based detection and prevention of network attacks.
D. Single mode IP communication for a fiber line between remote sites.
[多项选择]Which statements describe the routing protocol OSPF?（）
A. It supports VLSM.
B. It is used to route between autonomous systems.
C. It confines network instability to one area of the network.
D. It increases routing overhead on the network.
E. It allows extensive control of routing updates.
F. It is simpler to configure than RIP v2.
[单项选择]Cisco Small Business products address which installation requirement more effectively than standard Cisco products?（）
A. wireless technology integration
B. use of advanced reporting functions
C. VPN technology integration
D. minimal technical complexity
[单项选择]Which statement is true about the command ipv6 ospf 1 area 0?（）
A. It must be issued before the network command to enable the OSPF pr ocess for IPv6.
B. It must be issued after the network command to enable the OSPF process for IPv6.
C. It must be issued in router global configuration mode to enable the OSPF process for IPv6.
D. It must be issued in interface configuration mode to ena ble the OSPF process for IPv6.
[多项选择]When designing a converged network, which measures can be taken at the building access layer to help eliminate latency and ensure end-to-end quality of service can be maintained? （）
A. rate limit voice traffic
B. configure spanning-tree for fast link convergence
C. isolate voice traffic on separate VLANs
D. classify and mark traffic close to the source
