更多"Which of the following provides Fib"的相关试题:
[单项选择]Which of the following provides the MOST redundancy for a corporate server network?（）
A. Server-to-server replication
B. Server clustering
C. Hot site
D. Disk-to-disk replication
[单项选择]Which of the following provides the BEST security and accountability for a Data Center?（）
A. Entry logging
B. Combination locks
C. Card keys
D. Dead bolts
[单项选择]Which of the following provides a logical grouping of database objects?（）
A. View
B. Table
C. Schema
D. Buffer pool
[单项选择]Which of the following provides the MOST storage capacity without fault tolerance?（）
A. RAID 1
B. SAS
C. SAT A
D. JBOD
[单项选择]Which statement about Fibre Channel communications is correct?（）
A. It operates much like TCP.
B. Flow control is only provided by QoS.
C. It must be implemented in an arbitrated loop.
D. Communication methods are similar to those of an Ethernet bus.
E. N_Port to N_Port connections use logical node connection points.
[单项选择]Fibre channel requires which of the following elements?（）
A. FC Initiator
B. Multi-Mode fibre
C. Physical Adapter
D. Fibre Target Management Agent
[单项选择]A Fibre Channel fabric (or Fibre Channel switched fabric, FC-SW) is a switched fabric of Fibre Channel devices enabled by a Fibre Channel switch. Fabrics are normally subdivided by Fibre Channel zoning.Each fabric has a name server and provides other services. Higher redundancy over FC-AL, P2P.Which path selection protocol is used by Fibre Channel fabrics?（）
A. OSPF
B. RIP
C. FSPF
D. VSANs
[多项选择]Which of the following commands provides similar information about the current configuration ofactive local Ethernet adapters? (Select TWO)（）
A. traceroute
B. ipconfig
C. ifconfig
D. route
E. hostname
[单项选择]A network IPS provides which of the following?（）
A. The layer 3 protocol on which other protocols like TCP and UDP communicate.
B. Enables the IPSec protocol on internal workstations.
C. Packet-based detection and prevention of network attacks.
D. Single mode IP communication for a fiber line between remote sites.
[单项选择]Which of the following RAID levels provides the HIGHEST fault tolerance possible?（）
A. RAID 0
B. RAID 5
C. RAID 6
D. RAID 10
[单项选择]Which of the following DNS record types provides the hostname to IP address mapping?（）
A. A record
B. NS record
C. CNAME record
D. MX record
[单项选择]Fibre channel requires which of the following elements？（）
A. FC Initiator
B. Multi-Mode fibre
C. Physical Adapter
D. Fibre Target Management Agent
[多项选择]Which two Fibre Channel features are not supported in Cisco Nexus 5500 and Nexus 5000 platforms？ （）
A. port security
B. fabric binding
C. IVR
D. port tracking
E. FICON
[单项选择] A customer intends to implement a Fibre Channel SAN at the production site. Replication will take place over a 10 kilometer Ethernet connection to a second site; however, only IP storage connectivity currently exists at the second site. Which is the most appropriate method of replication in this situation?（）
A. FC routing
B. FCoE connection
C. FC-IP tunneling
D. multi-protocol router
[单项选择]A customer has a Fibre Channel switch residing in a configuration where both production and test data coexist. Which of the following is the simplest method for ensuring that the two types of data do not flow through the same port?（）
A. VLAN
B. zoning
C. trunking
D. LUN masking
[多项选择]Which two of these correctly describe Fibre Channel? （）
A. supports multiple protocols
B. works only in a shared or loop environment
C. allows addressing for up to 4 million nodes
D. allows addressing for up to 8 million nodes
E. provides a high speed transport for SCSI payloads
F. may stretch to a distance of up to100 km before needing extenders
[单项选择] A system has two configured fibre channel cards, one of which, fsc0, has failed and must be replaced. Which command should an administrator use to remove the card device and attached child devices?（）
A. rmdev -Rdl fcs0
B. rmdev -cdl fcs0
C. rmdev -cdl fscsi0
D. rmdev -Rdl fscsi0
[单项选择]Which path selection protocol is used by Fibre Channel fabrics?（）
A. IVR
B. VoQ
C. FSPF
D. VSANs
E. SANTap
[多项选择]Fibre Channel, or FC, is a gigabit-speed network technology primarily used for storage networking.Fibre Channel is standardized in the T11 Technical Committee of the InterNational Committee for Information Technology Standards (INCITS), an American National Standards Institute (ANSI) Caccredited standards committee.Which two of these correctly describe Fibre Channel?（）
A. supports multiple protocols
B. works only in a shared or loop environment
C. allows addressing for up to 4 million nodes
D. provides a high speed transport for SCSI payloads
