更多"Given the following configuration o"的相关试题:
[单项选择]Given the following LSP configuration, which statement is true?（）label-switched-path lsp-xyz { to 10.200.1.1; primary path1; secondary path2; secondary path3; no-cspf; } path path1 { 10.200.10.1 strict; } path path2 { 10.200.20.1 strict; } path path3 { 10.200.30.1 loose; }
A. The router will use path1 when it is available and stable.
B. The router will use path3 when it is available and stable.
C. The router will attempt to establish path2 only when path1 and path3 are down.
D. The router will attempt to establish path1 only when path2 and path3 are down.
[多项选择] Given the following MPLS L2 configuration command: mpls-relay 10.1.1.1 4 Which two statements true? （）(Choose two.)
A. This command is applied to the core router facing interface.
B. This command is applied to the customer facing interface.
C. The 4 is locally significant and identifies the layer 2 circuit.
D. The 4 must match exactly on the peer router configuration on the remote end.
[单项选择] Given the following configuration， what command can be used to determine the physical path that traffic will be sent out upon？（） Port-profile type Ethernet name vm-data Switchport mode trunk Switchport trunk allowed vlan 200-210 Channel-group auto mode on mac-pinning State enabled Vmware port-group No shut Port-profile type vethernet name vlan-200 Switchport mode access Switchport vlan 200 State enabled Vmware port-group No shut
A. module vem X execute vemcmd show trunk
B. show module 3 internal pinning
C. module vem X execute vemcmd show port
D. show module vem mapping
E. show interface vethX pinning
[单项选择]Which of the following sentences given below means approximately the same as the proverb: "Don't count your chickens until they are hatched "
[单项选择] The following configuration commands exist only in an implementation plan document. An engineer does a copy/paste of these commands into configuration mode on Router R1. Which of the following answers is m ost accurate regarding the results?（） ip sla 1 icmp - echo 1.1.1.1 source -ip 2.2.2.2 ip sla schedule 1 start - time now life forever
A. The SLA operation will be configured but will not start until additional commands are used
B. The SLA operation is not comp letely configured so it will not collect any datA
C. The SLA operation is complete and working, collecting data into the RTTMON MIB
D. The SLA operation is complete and working but will not store the data in the RTTMON MIB without more configuration
[单项选择]Which of the following configuration management documentation types would an administrator useto know how and when to property install new network devices on the LAN?（）
A. Baseline configuration
B. Logical network diagram
C. Network policy
D. Wiring schematic
[多项选择]The following configuration command was entered into a router:ip route 172.16.3.0 255.255.255.0 192.168.2.4 Which of the following statements are true regarding this configuration change?（）
A. The default administrative distance is used.
B. The command is used to establish a static route.
C. The command is used to configure the router interfaces.
D. The command is used to establish a stub network.
E. The subnet mask for the source address is 255.255.255.0
[多项选择]The following configuration command was issued on router TK1:ip route 172.16.3.0 255.255.255.0 192.168.2.1.Which of the following statements are true regarding this command?（）
A. The command is used to establish a static route.
B. The default administrative distance is used.
C. The command is used to configure the default route.
D. The subnet mask for the source address is 255.255.255.0
E. The command is used to establish a stub network
[单项选择] An engineer has added the following configuration snippet to an implementation planning document. The configuration will be added to Router R1, whose Fa0/0 interface connects to a LAN to which Routers R2 and R3 also connect. R2 and R3 are already EIGRP neighbors with each of her. Assuming the snippet shows all commands on R1 related to EIGRP authentication, which answer lists an appropriate comment to be made during the implementation plan peer review?（） key chain fred key 3 key - string whehew interface fa0/0 ip authenticat ion key - chain eigrp 9 fred
A. The configuration is missing one authentication - related configuration command
B. The configuration is missing two authentication - related configuration commands
C. Authentication type 9 is not supported; type 5 should be u sed insteaD
D. The key numbers must begin with key 1, so change the key 3 command to key 1
[多项选择] Look at the following configuration below and select the statements that are true.（） RD2(config)#router ospf 100 RD2(config - router)# distance 180 10.1.10.1 0.0.0.0 match - me RD2(config -router)#! RD2(config - router) #ip access - list standard match - me RD2(config - std - nacl)# permit host 172.16.0.0
A. OSPF will have an AD of 180 for routes from 10.1.10.1 in the 172.16.0.0/16 range.
B. The neighbor RID is 10.1.10.1
C. OSPF will have an AD of 180 for all routes.
D. The local RID is 10.1.10.1
[单项选择] The following configuration exists on a router on one end of an IPv6 tunnel. Although the configuration added so far is correct, the configuration is incomplete. Which type of tunnel is most likely to be intended by the network engineer？（） interface loopback 1 ip address 192.168.1.1 255.255.255.255 interface tunnel 2 ipv6 address 2002:C0A8:10 1::1/64 tunnel source loopback 1
A. Automatic 6to4
B. Manually configured tunnel
C. ISATAP
D. GRE
[单项选择] The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration？（）
A. ermit all packets matching the first three octets of the source address to all destinations
B. permit all packet matching the last octet of the destination address and accept all source addresses
C. permit all packet matching the host bits in the source address to all destinations
D. permit all packet from the third subnet of the network address to all destinations
[多项选择] Router R1 has the following configuration. Assuming R1's F0/0 interface has a MAC address of 0200.0011.1111, what IPv6 addresses will R1 list for interface F0/0 in the output of the show ipv6 interface brief command?（） interface f0/0 ipv6 address 2345:0:0:8::1/64
A. 2345:0:0:8::1
B. 2345:0:0:8:0:FF:FE11:1111
C. FE80::8:0:FF:FE11:1111
D. FE80:0:0:8::1
[多项选择] Examine the following configuration on Router R1. R1's show ip route 172.16.4.1 command list s a route with outgoing interface S0/1/1. Host 172.16.3.3 uses telnet to connect to host 172.16.4.1.What will Router R1 do with the packets generated by host 172.16.3.3 because of the telnet,assuming the packets enter R1's F0/0 interface?（） interface Fastethernet 0/0 ip address 172.16.1.1 255.255.255.0 ip policy route - map Q2 ! route - map Q2 permit match ip address 101 set interface s0/0/1 ! access - list 101 permit tcp host 172.16.3.3 172.16.4.0 0.0.0.255
A. The packet will be forwarded out S0/0 /1, or not at all.
B. The packet will be forwarded out S0/0/1 if it is up.
C. The packet will be forwarded out S0/1/1 if it is up.
D. The packet will be forwarded out S0/1/1 if it is up, or if it is not up, out s0/0/1.
E. The packet will be forwarded o ut S0/0/1 if it is up, or if it is not up, out s0/1/1.
[单项选择]Given the following directory structure: bigProject |--source | |--Utils.java | |--classes |-- And the following command line invocation: javac -d classes source/Utils.java Assume the current directory is bigProject,what is the result? （）
A. If the compile is successful, Utils.class is added to the source directory.
B. The compiler returns an invalid flag error.
C. If the compile is successful, Utils.class is added to the classes directory.
D. If the compile is successful, Utils.class is added to the bigProject directory.
