更多"Which two statements describe the c"的相关试题:
[多项选择]Which two statements describe the criteria bandwidth detection uses to dynamically alter bandwidth allocation?（）(Choose two.)
A. Throughput is raised as latency decreases.
B. Throughput is based on available bandwidth.
C. Throughput is lowered as latency decreases.
D. Latency is measured by SYNs returned for each metapacket
[多项选择]Which two statements describe characteristics of IPv6 unicast addressing?（）
A. Global addresses start with 2000::/3.
B. Link-local addresses start with FE00:/12.
C. Link-local addresses start with FF00::/10.
D. There is only one loopback address and it is ::1.
E. If a global address is assigned to an interface, then that is the only allowable address for the interface.
[多项选择]Which two statements describe the forwarding table in the Junos OS?（）
A. The forwarding table contains all known routes.
B. The forwarding table stores a subset of information from the routing table.
C. Junos devices use the forwarding table to compare incoming packets against existing entries to determine the next hop.
D. If multiple matches exist, the forwarding table uses the least-specific entry to forward packets toward the destination.
[多项选择]Which two statements describe the default routing policy for BGP?（）
A. Advertise only locally originated routes.
B. Accept all BGP routes and import into inet.0.
C. Advertise all active BGP routes.
D. Advertise only EBGP routes.
[多项选择]Which two statements describe the Cisco implementation of VLANs?（）
A. VLAN 1 is the default Ethernet VLAN.
B. CDP advertisements are only sent on VLAN 1002.
C. By default, the management VLAN is VLAN 1005.
D. By default, the switch IP address is in VLAN 1005.
E. VLAN 1002 through 1005 are automatically created and cannot be deleted.
[多项选择]Which two statements describe the advantages to the use of RIP over the use of OSPF?（）
A. RIP requires less time to converge
B. RIP uses less bandwidth
C. RIP is less complex to configure
D. RIP demands fewer router resources
E. RIP has a more accurate metric
[多项选择]Which two statements describe the behavior of the server's SQL mode?（）
A. The server's SQL mode determines how the server should behave when performing data validation check and interpreting different forms of syntax
B. The server's SQL mode determines whether the server should be read-only or should accept commands such as INSERT and UPDATE
C. The server's SQL mode can be changed at the session level with a SET SESSION sql_mode="new_value" command
D. The server's SQL mode, when globally set on a slave server, applies to events sent from the master
[多项选择]Which statements describe two of the benefits of VLAN Trunking Protocol?（）
A. VTP allows routing between VLANs.
B. VTP allows a single switch port to carry information to more than one VLAN.
C. VTP allows physically redundant links while preventing switching loops.
D. VTP simplifies switch administration by allowing switches to automatically share VLAN configuration information.
E. VTP helps to limit configuration errors by keeping VLAN naming consistent across the VTP domain.
F. VTP enhances security by preventing unauthorized hosts from connecting to the VTP domain.
[多项选择]Which two statements accurately describe a broadcast domain?（）
A. Broadcast domains requiere that the participating devices connect to common swithces or hubs
B. Broadcast domains consist of devices reachable by frames addressed to the Layer 2 broadcast address
C. Broadcast domains requiere a gateway device such a router
D. Broadcast domains consist of devices that reside on the same VLAN
[多项选择]Which two statements correctly describe a situation in which an Active/Standby Service Module design is being used?（）
A. Troubleshooting is more complicated.
B. Service and switch modules are underutilized.
C. Layer 2 adjacency is required with the servers that use this design.
D. Layer 3 adjacency is required with the servers that use this design.
E. Load balancing will always occur across both access layer uplinks.
