更多"The router receives a login request"的相关试题:
[单项选择]A metro Ethernet user is connected using a PPP over Ethernet service.How many Layer 2 headers are attached to each IP datagram?（）
A. 1
B. 2
C. 3
D. 4
[单项选择]When configuring the router to support dynamic PPPoE interfaces, which command string controls the number of sessions supported?（）
A. autoconfig ppp
B. ppp authentication
C. encapsulation pppoe
D. profile pppoe dynamic
[单项选择]The ERX Edge Router is configured for PPP over Ethernet without using VLAN tagging. How many PPP over Ethernet major interfaces can be configured per port?（）
A. 1
B. 100
C. 2048
D. 4096
[单项选择]You are upgrading your Cisco router IOS from a TFTP server over the network. The upgrade procedure is stopped and you are prompted to erase the current flash contents before continuing. What is most plausible reason for this? （）
A. There is insufficient room for more than one image.
B. The router has detected a copy of the current software image on the TFTP server.
C. The file can be relocated and not compressed.
D. The image to load is a binary executable file.
[多项选择] Router R1 is three router hops away from subnet 10.1.1.0/24. According to various show interfaces commands, all three links between R1 and 10.1.1.0/24 use the following settings: bandwidth: 1000, 500, 100000 and delay : 12000, 8000, 100. Which of the following answers correctly identifies a value that feeds into the EIGRP metric calculation？（）
A. Bandwidth of 101,500
B. Bandwidth of about 34,000
C. Bandwidth of 500
D. Delay of 1200
E. Delay of 2010
F. Delay of 20100
[单项选择]A router receives a packet from a neighbor with an MPLS shim header value of 0.What does the router do with this packet?（）
A. It performs a label pop operation and an IP lookup.
B. It performs a label swap operation and an IP lookup.
C. It sends an error message toward the egress router.
D. It sends an error message toward the ingress router.
[单项选择]A router learns about a remote network from EIGRP, OSPF, and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network（）。
A. The router will use the static route.
B. The router will use the OSPF route.
C. The router will use the EIGRP route.
D. The router will load balance and use all three routes.
[单项选择] Servlet A receives a request that it forwards to servlet B within another web application in the same webcontainer. Servlet A needs to share data with servlet B and that data must not be visible to other servlets inA’s web application. In which object can the data that A shares with B be stored？（）
A. HttpSession
B. ServletConfig
C. ServletContext
D. HttpServletRequest
E. HttpServletResponse
[单项选择]A router leams about a remote network from EIGRP.OSPF. and a static route. Assuming all routing protocols are using their default administrative distance, which route will the router use to forward data to the remote network?（）
A. The router will use the static route.
B. The router will use the OSPF route.
C. The route will use the EIGRP route.
D. The router will load balance and use all three routes.
[单项选择] Router R1 lists the following output from a show command. Which of the following is true about R1?（） R1# show ip v6 interface f0/0 FastEthernet0/0 is up, line protocol is up IPv6 is enabled, link - local address is FE80::213:19FF:FE12:3456 No Virtual link - local address(es): Global unicast address(es): 2000::4:213:19FF:FE12:3456, subnet is 2000:0:0:4::/64 [EUI] Jo ined group address(es): FF02::1 FF02::2 FF02::1:FF:12:3456
A. R1's solicited node multicast address is FF02::1:FF:12:3456.
B. R1's 2000::4:213:19FF:FE12:3456 address is a global unicast with all 128 bits statically configured.
C. Address FF02::2 is R1's solicited node multicast.
D. R1's solicited node multicast, not listed in this output, would be FF02::213:19FF:FE12:3456.
[单项选择]When a router has to make a rate transition from LAN to WAN, what type of congestion needs should be considered in the network design?（）
A. RX-queue deferred
B. TX-queue deferred
C. RX-queue saturation
D. TX-queue saturation
E. RX-queue starvation
F. TX-queue starvation
[多项选择] The following output was taken from Router R3. A scan of R3's configuration shows that no bandwidth commands have been configured in this router. Which of the following answers lists configuration settings could be a part of a configuration tha t results in the following output?（） R3#show ip ospf interface brief Interface PID Area IP Address/Mask Cost State Nbrs F/C Se0/0/0.2 3 34 10.10.23.3/29 647 P2P 1/1 Se0/0/0.1 3 34 10.10.13.3/29 1000 P2P 1/1 Fa0/0 3 34 10.10.34.3/24 20 BDR 1/1
A. An a uto - cost reference - bandwidth 1000 command in router ospf mode
B. An auto - cost reference - bandwidth 2000 command in router ospf mode
C. An ip ospf cost 1000 interface S0/0/0.1 command in router ospf mode
D. An auto - cost reference - bandwidth 64700 command i n router ospf mode
[单项选择]Router R1, in ASN 11, learns a BGP route from BGP peer R22 in ASN 22. R1 and then uses BGP to advertise the route to R2, also in ASN 11. What ASNs would you see in the BGP table on R2 for this route?（）
A. 22
B. 11
C. 1
D. None
[多项选择]In a PPP over ATM environment,which two PPP authentication methods are supported by the ERX Edge Router?（）
A. IKE
B. PAP
C. CHAP
D. MSCHAP
[单项选择]Router A is unable to reach Router B.Both routers are running ios version 12.0.After reviewing the command output and graphic,what is the most likely cause of the problem?（）
A. incorrect bandwidt h configuration
B. incorrect LMI configuration
C. incorrect map statement
D. incorrect IP address
[多项选择] Router R1 is configured as shown below: router eigrp 100 network 10.0.0.0 eigrp stub Based on the information shown above, which two types of routes will be advertised？（）
A. Receive - only
B. Stub
C. Static
D. Summary
E. Connected
F. Dynamic
[单项选择] Router B1, an internal router in area 1, displays the following output. The only two ABRs connected to area 1 are performing Type 3 LSA filterinG. Which of the following answers is true based on the information in the output from B1?（） R1# show ip route 10.1.0.0 255.255.0.0 longer - prefixes ! Legend lines omitted for brevity 10.0.0.0/8 is variably subnetted, 17 subnets, 3 masks O 10.1.2.0/24 [110/658] via 10.10.13.1, 00:00:32, Serial0/0/0.1 O IA 10.1.1.0/24 [110/658] via 10.10.23.2, 00:41:39, Ser ial0/0/0.2 O IA 10.1.3.0/24 [110/658] via 10.10.23.2, 00:41:39, Serial0/0/0.2
A. A Type 3 LSA for 10.2.2.0/24 was filtered by both ABRs
B. A Type 3 LSA for 10.1.2.0/24 was not filtered by both ABRs
C. A Type 3 LSA for 10.1.3.0/24 was not filtered by at least one ABR
D. A Type 3 LSA for 10.1.1.0/24 filtered by both ABRs
[单项选择] Router R1, a branch router, connects to the Internet using DSL. Some traffic flows through a GRE and IPsec tunnel, over the DSL connection, and into the core of an Enterprise network. The branch also allows local hosts to communicate directly with public sites in th e Internet over this same DSL connection. Which of the following answers defines how the branch NAT config avoids performing NAT for the Enterprise directed traffic but does perform NAT for the Internet - directed traffic?（）
A. By not enabling NAT on the I Psec tunnel interface
B. By not enabling NAT on the GRE tunnel interface
C. By configuring the NAT - referenced ACL to not permit the Enterprise traffic
D. By asking the ISP to perform NAT in the cloud
