更多"When troubleshooting a possible mis"的相关试题:
[单项选择]When troubleshooting hardware issues with a server, which of the following is MOST likely to cause a problem in receiving vendor support?（）
A. Third party cables
B. Third party memory
C. Signed drivers
D. Server type
[单项选择]When troubleshooting an EIGRP connectivity problem, you notice that two connected EIGRP routers are not becoming EIGRP neighbors. A ping between the two routers was successful.What is the next thing that should be checked?（）
A. Verify that the EIGRP hello and hold timers match exactly.
B. Verify that EIGRP broadcast packets are not being dropped between the two routers with the show ip EIGRP peer command.
C. Verify that EIGRP broadcast packets are not being dropped between the two routers with the show ip EIGRP traffic command.
D. Verify that EIGRP is enabled for the appropriate networks on the local and neighboring router.
[单项选择]When troubleshooting ATM, which command would allow you to test reachability from one side of an ATM cloud to the other?（）
A. ping atm vci 0.100 interface at-0/1/0 end-to-end
B. ping atm vci 0.100 interface at-0/1/0 circuit
C. ping atm vci 0.100 interface at-0/1/0 far-end
D. ping atm vci 0.100 interface at-0/1/0 final-hop
[单项选择]When troubleshooting a Frame Relay connection, what is the first step when performing a loopback test?（）
A. Set the encapsulation of the interface to HDLC
B. Place the CSU/DSU in local-loop mode
C. Enable local-loop mode on the DCE Frame Relay router
D. Verify that the encapsulation is set to Frame Relay
[单项选择]When an administrator is troubleshooting a system, which of the following describes the NEXT course of action if a change does not solve the problem?（）
A. Establish a new theory of probable cause.
B. Reverse the change.
C. Implement the next logical change.
D. Perform a root cause analysis.
[单项选择]When you are troubleshooting an ACL issue on a router,which command can help you to verify which interfaces are affected by the ACL?（）
A. show ip access-list
B. show access-list
C. list ip interface
D. show interface
E. show ip interface
[单项选择]When troubleshooting an 802.11g network. Which of the following can interfere with the network?（）
A. 2.4 GHz cordless phone
B. 900 MHz cordless phone
C. Bluetooth headset
D. Bluetooth printer
[单项选择]When troubleshooting the issue， you notice the election of a new root bridge with an unknown MAC address. Knowing that all access ports have the PortFast feature enabled， what would be the easiest way to resolve the issue without losing redundant links？（）
A. Enable bpduguard globally.
B. Enable rootguard.
C. Enable loopguard.
D. Enable spanning tree.
E. Enable UDLD
[单项选择]When traveling, it is possible that you may be advised to take the travelers' checks, which provide a secure ______ to carrying your money in cash.
A. selection
B. preference
C. alternative
D. substitute
[单项选择]When troubleshooting hardware issues with a server， which of the following is MOST likely to cause a problem in receiving vendor support？（）
A. Third party cables
B. Third party memory
C. Signed drivers
D. Server type
[多项选择]When troubleshooting duplex mismatches， which two are errors that are typically seen on the half duplexend？（）
A. excessive collisions
B. FCS errors
C. runts
D. late collisions
[单项选择]When troubleshooting a network， the output of the command show interfaces indicates a large number of runts. What is a runt？（）
A. the number of packets that are discarded because they exceed the maximum packet size of the medium
B. errors created when the CRC generated by the originating LAN station or far-end device does not match the checksum calculated from the data received.
C. the number of packets that are discarded because they are smaller than the minimum packet size of the medium
D. the number of received packets that were ignored by the interface because the interface hardware ran low on internal buffers
E. the number of times that the interface requested another interface within the router to slow down
[多项选择]When you are troubleshooting duplex mismatches， which two errors are typically seen on the full- duplexend？（）
A. runts
B. FCS errors
C. interface resets
D. late collisions
[单项选择]A workstation is having connectivity issues when being added to the domain. Which of the following commands would allow the administrator to see the DNS and WINS servers that are currently configured for the workstation?（）
A. Ipconfig
B. Nslookup
C. Netstat
D. Nbtstat
[单项选择]Only when ______ possible for all the people present to make a final decision.
A. does the director come will it be
B. the director comes will it be
C. has director come it will be
D. the chief editor comes it will be
