更多"Which parameters must you select wh"的相关试题:
[多项选择]Which three elements must be used when you configure a router interface for vlan trunking?（）
A. one IP network or subnetwork for each subinterface
B. subinterface numbering that matches vlan tages
C. subinterface encapsulation identifiers that match vlan tags
D. a management domain for each subinterface
E. one physical interface for each subinterface
F. one subinterface per vlan
[单项选择]What parameters must you specify when you enable EIGRP routing?（）
A. The broadcast address, and AS number
B. The network number and AS number
C. EIGRP routing, network number and passive interface
D. EIGRP routing, network number, and AS
[单项选择]Which options must you configure while performing an automated Tablespace Point-in-Time Recovery(TSPITR) by using Recovery Manager (RMAN)?（）
A. New channels for restore and recovery tasks
B. New name for the data files of the tablespace
C. Auxiliary name for the data files of the tablespace
D. Auxiliary destinations for an auxiliary set of data files
[单项选择]Which is the telephone number you need when you intend to book a double room at Ramada Inn
A. 1-800-667-8868 or (250) 374-4788.
B. 1-800-575-7322 or (250) 851-0111.
C. 1-800-726-3626 or (250) 374-1218.
D. 14100-663-2832 or (260) 374-0358.
[多项选择]Which two considerations must you take into account when deploying a Junos Pulse Access Control Service cluster?（）
A. State synchronization occurs only through the internal network interface card (NIC)
B. Latency of the WAN must be less than 300 ms.
C. Authenticating endpoints must be on the same LAN segment.
D. Cluster members must use the same hardware platfor
[单项选择]Which of the following must occur when installing SCSI devices into the server?（）
A. Terminate the back end of the chain.
B. Set the jumper to device ID 0.
C. Terminate both ends of the chain.
D. Set the jumper to cable select.
[单项选择]When you are in England, you must remember that ______.
[单项选择]When you go by bus in England, you must be careful because ______.
[单项选择]Which describes the default behavior when you create a table?（）
A. The table is accessible to all users.
B. Tables are created in the public schema.
C. Tables are created in your schema.
D. Tables are created in the DBA schema.
E. You must specify the schema when the table is created.
