更多"[多选题]关于xGW(PDSN)，当AAA下发了Framed-pool"的相关试题:
[多选题]关于xGW(PDSN)，当AAA下发了Framed-pool=p1参数给PDSN，PDSN侧p1地址池类型可设置为（）。
On the xGW(PDSN), when the AAA sends the parameter Framed-Pool=p1 to the PDSN, the type of the IP pool "p1" should be set to ( ) on the PDSN side.
A.local
B.aaa
C.assigned
D.static
[判断题]对于xGW PDSN，当存在AAA时，PDSN可以不配置aaa-profile。
A.正确
B.错误
[单选题]关于xGW(PDSN)的aaa-profile配置，主用AAA宕机后切换至备用AAA，哪个模式需要手动回切？
A.primary-prior
B.primary-standby
C.master-prior
D.master-slave
[单选题]关于xGW(PDSN)，配置了主备AAA，由于主用AAA故障，业务切换到备用AAA，回切时需要将aaa-profile工作模式配置为（）。
On the xGW(PDSN), both the master AAA and the slave AAA are configured. After services are switched over to the slave AAA when the master AAA becomes faulty, we need to set the work mode of the aaa-profile to ( ) during switchback.
A.load-balance
B.primary-prior
C.primary-standby
D.round-robin
[单选题]关于xGW(PDSN)，下列哪个命令可以显示当前的路由表？
On the xGW(PDSN), the command ( ) is used to get the current routing table.
A.show ip route
B.show ip routing table
C.show ip protocol routing
D.show running-config
[单选题]关于xGW(PDSN)，哪个命令可以获取单板的内存利用率？
On the xGW(PDSN), we can run the following command to get the memory utilization ratio: ( ).
A.show processor
B.show hardware
C.show running-information
D.show mem-usage
[多选题]关于xGW(PDSN)，下列哪些服务可以通过acl限制？
On the xGW(PDSN), the following services can be restricted through the ACL: ( ).
A.telnet
B.ssh
C.ftp
D.snmp
E.
F.123
G.1234
[多选题]关于xGW(PDSN)，分配IP失败，可能的原因有（）。
On the xGW(PDSN), if IP assignment fails, what are the possible causes? ( )
A.IP池中无可用的IP
There is no available IP address in the IP pool.
B.AAA下发了Framed-pool，但是PDSN没有在realm中配置该IP池
AAA sends the Framed-Pool, but this IP pool is not configured in the realm of the PDSN.
C.PDSN配置IP池的时候使用VRF，但是AAA没有下发VRF ID
The VRF is used when you configure the IP pool on the PDSN, but AAA doesn't send the VRF ID.
D.AAA下发了Framed-Pool，但是PDSN侧该IP池的属性是local
AAA has sent the Framed-Pool, but the attribute of this IP pool is "local" on the PDSN side.
[单选题]xGW-PDSN中创建一个新的AAA-profile，这个AAA-profile默认使用的编码Radius属性集是？（ ）
A.中国电信属性集
B.V3.1属性集
C.HRPD属性集
D.P100属性集
[多选题]xGW(PDSN)不发送鉴权请求到AAA，可能的原因有（）。
If the xGW(PDSN) doesn't send the authentication request to the AAA, what are the possible causes? ( )
A.PDSN与AAA的安全关联配置不匹配
The security association configurations of the PDSN and the AAA do not match.
B.配置了force-local-auth enable
"force-local-auth enable" is configured.
C.xGW(PDSN)出现鉴权报文无应答告警
The alarm "not receive authentication reply for many times" occurs on the xGW(PDSN).
D.AAA宕机
The AAA is down.
[多选题]关于xGW(PDSN), 默认配置下，AAA未下发额外的参数，下列哪些条件会触发计费终止消息和计费开始消息？
For the xGW(PDSN), by default, if no extra parameter is returned by the AAA, the Accounting-Stop message and Accounting Start message will be triggered under the following situations: ( ).
A.终端先休眠再激活
The terminal becomes dormant first and is then activated.
B.终端跨PCF切换
The terminal hands off between different PCFs.
C.空口参数改变
Airlink parameters are changed.
D.发生PPP重协商
PPP re-negotiation happens.
[单选题]对于xGW PDSN，MPU固定在（）槽位。
For the xGW PDSN, the MPU is fixed in slot ( ).
A.20/21
B.0/1
C.18/19
D.3/4
[单选题]对于xGW PDSN，SFU固定配置在（）槽位。
For xGW PDSN, SFU is fixed in slot ( ).
A.16/17/18/19
B.0/1/2/3
C.4/5/6/7
D.8/9/10/11
