更多"[单选题]When autopilot joins, the orde"的相关试题:
[单选题]Who controls rudder when autopilot engages?
A. SEC
B. FAC
C. ELAC
[单选题]which of the following control the rudder trim actuator in manual mode?
A. only FMGC
B. only FAC
C. FMGC and FAC
[单选题]If windshear, stall, or GPWS messages are triggered, all the TCAS aural messages are:
A. A. Normal warning
B. B. Suppressed
C. C. Not sure
[单选题]When happens when CAPT3 is selected?
A. Pilot uses the observer’s audio equipments
B. Observer uses pilot’s audio equipments
C. Pilot uses third occupant’s ACP
[单选题]When RAM AIR is at ON position, when use automatic control operation and differential pressure is lower than 1 psi, the outflow valve is to
A.100%
B.80%
C.50%
[单选题]When did TAT heating?
A. In flight, not on ground
B. On ground, not in flight
C. Only on ice condition
[单选题]When takeoff mode engages:
A. autothrust engages automatically and be active
B. autothrust engages automatically but be inactive
C. autothrust does not engage automatically and the engine is controlled by thrust levers
[单选题]When automatic refueling is completed
A. “END” light flashes green
B. The green light comes on steady
C. No indication, selected fuel capacity equals to actual fuel capacity
[单选题]When ANN LT selector test:
A. Turns on all flight deck annunciator lights
B. Displays 8’s in all Liquid Crystal Displays (LCDs)
C. Both correct
[单选题]Engine LP fuel valve closes when
A. the pressure of fuel pressurization pump descends
B. engine shut-down or engine fire alarm pushbutton out
C. engine fire alarm detection system detects ENG FIRE PUSH
[单选题]Aural warning will be stopped when
A. the MASTER WARN light is pressed (except for red warnings such as OVERSPEED or STALL) or the warning condition no longer exists
B. the EMER CANC pb on the ECAM control panel is pressed
C. Both of the above
[单选题]When is the autopilot engaged?
A. After the engine is started on the ground
B. Not sooner than 5 seconds after lift-off
C. Not sooner than 5 seconds after lift-off and the aircraft is 100ft above
[单选题]When Automatic Pressurization lose outer procedure signal:
A. Pressurization system must be manually operated.
B. No any action
C. Landing elevation should be selected.
[单选题]When did the STROBE work?
A. After aircraft liftoff, turn to AUTO position
B. Turn to ON position
C. Both correct
[单选题]When both yaw damping engage:
A. yaw damping 1 is in priority and yaw damping actuating cylinder 2 follows
B. yaw damping 2 is in priority and yaw damping actuating cylinder 1 follows
C. yaw damping 1 and 2, two actuating cylinders are pressurized
[单选题]When taxi on contaminated runways,
A. avoid high thrust settings and taxi at low speed. Note that antiskid is inoperative at low taxi speeds.
B. there is special provisions on the flap/slat operation for takeoff and landing.
C. both of the above statements are correct.
[单选题]When will the THS failure?
A. after a failure occurs in yellow and green hydraulic systems
B. after a failure occurs in blue hydraulic systems
C. after a failure occurs in FAC(1)2
[单选题]When executing the emergency evacuation procedure, which one below is correct?
A.F/O may select engine control to OFF and press the FIRE button, and it must be confirmed by captain.
B.F/O may select engine control to OFF and press the FIRE button without acknowledgment of captain.
[单选题] When the information requested cannot be obtained, say: ( ).
A. No information.
B. Stand by on VHF channel … .
C. Negative.
D. Over.