更多"[单选题]When bank angle protection is "的相关试题:
[单选题]When angle-of-attack protection is active, the THS setting is limited between the setting at the aircraft’s entry into this protection and 3.5 ° nose down. (Neither the pilot nor the system can apply additional nose-up trim).Similarly, when is the THS setting limited to values between the actual setting and 3.5 ° nose down
A. when the load factor is higher than 1.25 g
B. when the aircraft exceeds 33 ° of bank
C. all of the above
[单选题]If Angle-of-Attack protection is active, and the pilot maintains full lateral deflection on the sidestick, the bank angle will not go beyond ____°.
A. 40°
B. 45°
C. 67°
[单选题]When the bank angle exceeds 45 °, all the PFD symbols, except those for attitude, speed, heading, altitude, and vertical speed, disappear. What is the bank angle below which the display returns to normal?
A.33
B.40
C.45
[单选题]When RAM AIR is at ON position, when use automatic control operation and differential pressure is lower than 1 psi, the outflow valve is to
A.100%
B.80%
C.50%
[单选题]When difference between roll or pitch angle, displayed on the CAPT and F/O PFD greater than ____°, local warning CHECK ATT will appeared on PFD.
A. A. 3
B. B. 5
C. C. 7
[单选题]When pitch angle exceeds 25 ° nose up or 13 ° nose down, all the PFD displays except attitude, speed, speed trend, heading, altitude, and vertical speed disappear. What is the angle beyond which a large red arrowhead indicates that the attitude has become excessive and shows the direction to move the nose in order to reduce it？
A.22
B.25
C.30
[单选题]When “NO AUTO TILT” message displayed on ND, which is correct?
A. A. radar lost AUTO TILT/MULTISCAN function
B. B. Manual mode still available
C. C. Both correct
[单选题]When MULTISCAN toggle switch at AUTO position, the antenna tilt number on ND indicates:
A. A. The average of upper and under part of beam incidence
B. B. The angle between horizontal line and radar beam axie
C. C. The angle between radar beam axie and actual track angle
[单选题]When ELT selector is set on ARMED, the ELT transmits an emergency signal (on 121.5,243 and 406.025MHZ) in the case of impact. Which of the following statement is correct?
A. Once the signal is transmitted, it cannot be suspended
B. There’s no related indication in the cockpit even if the signal is transmitted
C. TEST can be selected to reset the ELT and stop signal transmission
[单选题]When NO SMOKING sw at AUTO, on which condition EXIT signs come on?
A. Flaps are extended at least 15°
B. The landing gear is extended
C. Both correct
[单选题]When SEAT BELT sw at AUTO, on which condition FASTEN SEAT BELT and RETURN TO SEAT sign come on simultaneously?
A. Flaps are extended at least 15°
B. The main landing gear is extended
C. Both correct
[单选题]If power transfer unit is set on AUTO, when does it function automatically?
A. When blue system is lost
B. When the differential pressure between the green and the yellow systems is greater than 500psi
C. When the differential pressure between the green and the yellow systems is detected
[单选题]When GEN pb-sw is AUTO，it will become amber if load > 100 %. Which of the following conditions will also let GEN becomes amber？
A. The voltage legend becomes amber if V > 120 V or V < 110 V.
B. The frequency legend becomes amber if F > 410 Hz or F < 390 Hz.
C. all of the above
[单选题]When select wing anti-ice, idle EPR will automatically____.
A. Reduce
B. Increase
C. No change
[单选题]If BAT pb is at AUTO, when will battery be charged and when will the charging cycle end?.
A. Battery voltage below 26.5 V (battery charge). The charging cycle ends when battery charge current goes below 4
B. Battery voltage below 26.5 V (battery charge). The charging cycle ends when battery charge current goes below 2 A.
C. Battery voltage below 25.5 V (battery charge). The charging cycle ends when battery charge current goes below 4 A.
[单选题]主、备母钟TR1、TR2、TR3指示灯正常状态（ ）
A.红色灯长亮
B.红色灯闪烁
C.绿色色灯长亮
D.绿色灯闪烁
[单选题]如果TR1和TR2失效，以下说法哪种正确？
A. DC BUS1，DC BUS 2 和DC BAT BUS同时失效
B. DC ESS BUS 由ESS TR供电
C. 以上都对
[单选题]Which?of?the?following?is?true，if TR1 and TR2 are failure ？
A. DC BUS 1, DC BUS 2, and DC BAT BUS are lost at the same time
B. The DC ESS BUS is supplied by the ESS TR.
C. all of the above
