更多"Fusible plugs are installed in fire"的相关试题:
[单项选择]Emergency generator is installed on board mainly to （）
A. connect to the busbar when the load increasing
B. supply power specially to charging panel
C. be put into operation during the ship arriving at or leaving port
D. ensure the power supply to critical equipment after the main switchboard out of power
[单项选择]Boilers and cylinders are（）.
A. raw metallic products
B. finished metallic products
C. consumable products
D. Manufactured goods of large Size
[单项选择]Oxygen corrosion in auxiliary boilers is prevented by treating the boiler feed tank with either sodium （）
A. sulfite or hydrazine
B. sulfite or hygroscopic sulfite
C. bromide or hydrazine
D. bromide or hygroscopic sulfite
[单项选择]The procedures recommended for auxiliary boilers having high salinity include （）.
A. treating with oxygen scavengers
B. securing the boiler and giving it a blowing down
C. increasing the pH
D. reducing the phosphate level
[单项选择]Auxiliary boilers are divided into several classifications, one of which is（）
A. fire-tube controlled circulation
B. fire-tube supercritical circulation
C. water-tube natural circulation
D. water-tube express circulation
[单项选择]In boilers, besides maintaining the burner atomizers, air diffuser vanes, fuel temperature, forced draft fan, fuel pump and other hardware in good condition, there are some adjustments on the （）that can produce a good flame for the most efficient operation.
A. fuel-air ratio
B. compression ratio
C. fuel rack
D. viscosity index
[单项选择]Fusible-link fire dampers are operated by（）.
A. 8the heat of a fire melting the link
B. a break-glass and pull-cable system
C. electrical controls on the bridge
D. a mechanical arm outside the vent duct
[单项选择]Generating tubes in waste heat boilers are finned to （）.
A. reduce gas flow turbulence
B. prevent exhaust gas corrosion
C. increase the rate of combustion
D. increase the rate of heat transfer
[单项选择]Auxiliary boilers can be classified as（）
A. water-tube natural circulation boilers
B. fire-tube boilers
C. water-tube forced circulation boilers
D. all of the above
[单项选择]The purpose of designing some waste heat boilers with sinuous fire tubes, is to（）
A. increase exhaust gas velocity through the boiler
B. reduce accumulations of carbon deposits on the heat transfer surfaces
C. eliminate exhaust gas pulsations and noise
D. increase the rate of heat transfer to the waterside
[单项选择]Who is in charge of the auxiliary boilers?（）
A. The chief engineer
B. The second engineer
C. The third engineer
D. The fourth engineer
[单项选择]The exhaust boilers are used to recover some of （） carried in the exhaust gas from the main engine.
A. water
B. oil
C. heat
D. steam
[单项选择]Intercoolers installed on starting air compressors, reduce the possibility of（）
A. dust entering the high pressure stage
B. lube oil carbonization
C. discharge pulsations
D. inter-stage vapor lock
[单项选择]Temperature control valves installed in the jacket cooling water system of a diesel engine modulates the rate of water flow through the （）.
A. cooling water pump
B. nozzle cooling passages
C. cylinder jackets
D. heat exchanger
[单项选择]The circular steel structure installed around the propeller of a towboat is the（）.
A. nozzle
B. shroud
C. strut
D. hood
[单项选择]Why are removable sleeves installed on centrifugal pump shafts?（）
A. They make it easier to replace the pump shaft packing
B. They can be economically replaced as they wear out
C. They can be removed when it is necessary to lighten the weight of the pump
D. They increase the strength of the shaft
[单项选择]A system administrator installed a new switch using a script to configure it. IP connectivity was tested using pings to SwitchB.Later attempts to access NewSwitch using Telnet from SwitchA faileD.Which statement is true?（）
A. Executing password recovery is required.
B. The virtual terminal lines are misconfigured.
C. Use Telnet to connect to RouterA and then to NewSwitch to correct the error.
D. Power cycle of NewSwitch will return it to a default configuration.
