更多"Boilers and cylinders are（）."的相关试题:
[单项选择]Oxygen corrosion in auxiliary boilers is prevented by treating the boiler feed tank with either sodium （）
A. sulfite or hydrazine
B. sulfite or hygroscopic sulfite
C. bromide or hydrazine
D. bromide or hygroscopic sulfite
[单项选择]The procedures recommended for auxiliary boilers having high salinity include （）.
A. treating with oxygen scavengers
B. securing the boiler and giving it a blowing down
C. increasing the pH
D. reducing the phosphate level
[单项选择]Auxiliary boilers are divided into several classifications, one of which is（）
A. fire-tube controlled circulation
B. fire-tube supercritical circulation
C. water-tube natural circulation
D. water-tube express circulation
[单项选择]In boilers, besides maintaining the burner atomizers, air diffuser vanes, fuel temperature, forced draft fan, fuel pump and other hardware in good condition, there are some adjustments on the （）that can produce a good flame for the most efficient operation.
A. fuel-air ratio
B. compression ratio
C. fuel rack
D. viscosity index
[单项选择]Generating tubes in waste heat boilers are finned to （）.
A. reduce gas flow turbulence
B. prevent exhaust gas corrosion
C. increase the rate of combustion
D. increase the rate of heat transfer
[单项选择]Auxiliary boilers can be classified as（）
A. water-tube natural circulation boilers
B. fire-tube boilers
C. water-tube forced circulation boilers
D. all of the above
[单项选择]The purpose of designing some waste heat boilers with sinuous fire tubes, is to（）
A. increase exhaust gas velocity through the boiler
B. reduce accumulations of carbon deposits on the heat transfer surfaces
C. eliminate exhaust gas pulsations and noise
D. increase the rate of heat transfer to the waterside
[单项选择]Mechanical lubricators for diesel engine cylinders are usually small reciprocating pumps which are （）.
A. operated manually once an hour
B. operated until the engine has started
C. placed into operation only at maximum load
D. adjustable to meet lubrication requirements
[单项选择]Fusible plugs are installed in fire-tube boilers to （）.
A. provide a means of draining the boiler
B. warn the engineer of low water level
C. cool the crown sheet at high firing rates
D. open the burners electrical firing circuits
[单项选择]Who is in charge of the auxiliary boilers?（）
A. The chief engineer
B. The second engineer
C. The third engineer
D. The fourth engineer
[单项选择]The exhaust boilers are used to recover some of （） carried in the exhaust gas from the main engine.
A. water
B. oil
C. heat
D. steam
[单项选择]The oil lubricating diesel engine cylinders usually contain additives formulated to impart a high degree of alkalinity to （） the acid conditions.
A. invade
B. provide
C. detergent
D. neutralize
[单项选择]CO2 cylinders equipped with pressure actuated discharge heads will discharge automatically when（）.
A. the discharge valve is open
B. the control box glass is broken
C. pressure from the control cylinders is detected
D. the control cylinders have been completely discharged
[单项选择]
Exhaust temperature increases in all cylinders, the possible cause may be（）
(1) increased scavenging air temperature
(2) air in fuel pumps and fuel valves
(3) fouling of air and gas passages
A. (1)+(2)
B. (1)+(3)
C. (2)+(3)
D. (1)+(2)+(3)
[单项选择]Successful combustion inside the cylinders of a diesel engine is dependent upon （）.
A. fine atomization
B. high temperature
C. good mixing of fuel and air
D. all of the above
[单项选择]Cylinders of marine diesel engines are normally cooled by （）.
A. sea water
B. fine mineral oil
C. sanitary water
D. fresh water
[单项选择]The sequence of fuel injection into cylinders is determined by （）.
A. the steering
B. the driven gear
C. the turning gear
D. the timing gear
[单项选择]Turbulence is created in the cylinders of a diesel engine to （）
A. obtain injection lag
B. help mix fuel and air
C. increase combustion pressure
D. utilize higher injection pressures
