题目详情
当前位置:首页 > 职业技能鉴定考试 > 轮机英语
题目详情:
发布时间:2024-01-30 19:48:31

[单项选择]Performance of a turbocharged engine can be improved by()
A. decreasing the amount of valve overlap
B. preheating the air intake
C. after-cooling the intake air
D. preheating light fuel

更多"Performance of a turbocharged engin"的相关试题:

[单项选择]An operating turbocharged diesel engine that suddenly loses power, is due to a/an()
A. restricted turbocharger air intake
B. oil leak into the turbocharger
C. dribbling injector
D. low fuel viscosity
[单项选择]In a main propulsion turbocharged diesel engine, the speed of the turbocharger varies according to the ()
A. governor droop
B. speeder spring tension
C. fuel rack lag
D. load on the engine
[单项选择]After-cooling of a turbocharged diesel engine will result in ()
A. higher torque but lower brake horsepower
B. lower torque but higher brake horsepower
C. higher torque and lower brake horsepower
D. lower torque and higher brake horsepower
[单项选择]The power output of a turbocharged diesel engine will drop if the cooling water flow through the after-cooler is interrupted because the ().
A. turbocharger stalls
B. exhaust pressure increases
C. air charge density decreases
D. scavenge effect increases
[单项选择]A turbocharged diesel engine will have an intake manifold pressure()
A. constantly decreasing as engine load increase
B. constantly increasing as the amount of supercharging increases
C. approximately equal to exhaust manifold pressure at all times
D. approximately equal to atmospheric pressure at all times
[单项选择]If the speed of a turbocharged diesel engine is maintained constant the turbocharger speed will ()
A. decrease until the engine speed increases
B. increase as the load increases
C. decrease as the load
D. increases remain unchanged
[单项选择]Diesel engine control can be obtained by the bridge ().
A. at any time
B. only after the engine room control station is switched to “bridge control”
C. whenever the secondary station is switched to "bridge control"
D. with the approval of the chief engineer only
[单项选择]Main diesel engine control can be obtained by the bridge ()
A. at any time
B. only after the engine room control station is switched to ‘bridge control’
C. whenever the secondary station is switched to ‘bridge control’
D. whenever the engine side control station is switched to ‘bridge control’
[单项选择]One cause of diesel engine surging can be a result of ()
A. injection pump plungers stuck or worn
B. low compression
C. solenoid stuck open
D. fuel tank too full
[单项选择]() of an engine crankshaft can be detected by measuring deflections of crank webs for each unit of the engine.
A. Misalignment
B. Length
C. Strength
D. Stresses
[单项选择]A turbocharged, four-stroke/cycle diesel engine has a larger valve overlap than a naturally aspirated four-stroke/cycle diesel engine, in order to in crease the ().
A. temperature of the exhaust gases
B. energy supplied to the turbocharger
C. air pressure to the intake manifold
D. purge of exhausted gases from the cylinders
[单项选择]In a turbocharged four-stroke/cycle diesel engine, the exhaust valve remains open until after top dead center and the intake valve opens before top dead center to().
A. produce a scavenging effect in the combustion space
B. equalize cylinder and exhaust manifold pressures
C. alleviate the difference in valve size between the intake and exhaust
D. flush out condensate that collects after each compression stroke
[单项选择]Combustion knock occurring in a diesel engine can be caused by ()
A. low coolant temperature
B. insufficient fuel
C. high ambient temperature
D. carbon buildup on the injector tips
[单项选择]White smoke exhausting from a diesel engine can be caused by ()
A. low combustion temperature
B. a leaking fuel nozzle check valve
C. late fuel injection
D. plugged oil-scraper ring hole
[单项选择]Low compression pressure in a diesel engine can be caused by()
A. improperly seating intake valves
B. leaking cylinder liner seal rings
C. late fuel injection timing
D. carbon deposits on the piston
[单项选择]Diesel engine lube oil can become contaminated as a result()
A. the water produced during combustion
B. the sulfur in the fuel
C. unburned fuel oil
D. all of the above
[单项选择]The most important factor in engine performance is the actual power output at the end of the crankshaft available for doing workThis is known as ().
A. indicated horsepower
B. brake horsepower
C. net horsepower
D. friction horsepower
[单项选择]If the engine can be started and maneuvered on high viscosity fuel, the ()of the fuel reaching the injectors should be raised to such a point that the viscosity is less than the required value, ie27c St.
A. pressure
B. temperature
C. viscosity
D. density

我来回答:

购买搜题卡查看答案
[会员特权] 开通VIP, 查看 全部题目答案
[会员特权] 享免全部广告特权
推荐91天
¥36.8
¥80元
31天
¥20.8
¥40元
365天
¥88.8
¥188元
请选择支付方式
  • 微信支付
  • 支付宝支付
点击支付即表示同意并接受了《购买须知》
立即支付 系统将自动为您注册账号
请使用微信扫码支付

订单号:

请不要关闭本页面,支付完成后请点击【支付完成】按钮
恭喜您,购买搜题卡成功
重要提示:请拍照或截图保存账号密码!
我要搜题网官网:https://www.woyaosouti.com
我已记住账号密码