题目详情
当前位置:首页 > 职业技能鉴定考试 > 航海英语
题目详情:
发布时间:2023-10-17 12:00:34

[单项选择]Two types of anchor shackles which are currently available are().
A. U-Type and posilok shackles
B. C-Type and wedge shackles
C. D-Type and bow shackles
D. wedge and kenter shackles

更多"Two types of anchor shackles which "的相关试题:

[多项选择] Into which two types of areas would an area border router (ABR) inject a default route?()
A. stub
B. the autonomous system of an exte rior gateway protocol (EGP)
C. NSSA
D. totally stubby
E. the autonomous system of a different interior gateway protocol (IGP)
F. area 0
[单项选择]A design modification of an anchor chain which prevents kinking is the().
A. detachable link
B. stud link
C. Kenter link
D. connecting link
[多项选择]Which two statements correctly describe a situation in which an Active/Standby Service Module design is being used?()
A. Troubleshooting is more complicated.
B. Service and switch modules are underutilized.
C. Layer 2 adjacency is required with the servers that use this design.
D. Layer 3 adjacency is required with the servers that use this design.
E. Load balancing will always occur across both access layer uplinks.
[多项选择]Which two statements about static NAT translations are true?()
A. They are always present in the NAT table.
B. They allow connection to be initiated from the outside.
C. They can be configured with access lists, to allow two or more connections to be initiated from the outside.
D. They require no inside or outside interface markings because addresses are statically defined.
[多项选择]Which two design recommendations are most appropriate when OSPF is the data center core routing protocol? ()
A. Never use passive interfaces.
B. Use NSSA areas from the core down.
C. Use totally stub areas to stop type 3 LSAs.
D. Use the lowest Ethernet interface IP address as the router ID.
E. Tune OSPF timers to enable OSPF to achieve quicker convergence.
[多项选择]Which two statements describe characteristics of IPv6 unicast addressing?()
A. Global addresses start with 2000::/3.
B. Link-local addresses start with FE00:/12.
C. Link-local addresses start with FF00::/10.
D. There is only one loopback address and it is ::1.
E. If a global address is assigned to an interface, then that is the only allowable address for the interface.
[多项选择]Which two statements describe the Cisco implementation of VLANs?()
A. VLAN 1 is the default Ethernet VLAN.
B. CDP advertisements are only sent on VLAN 1002.
C. By default, the management VLAN is VLAN 1005.
D. By default, the switch IP address is in VLAN 1005.
E. VLAN 1002 through 1005 are automatically created and cannot be deleted.
[多项选择]Which two statements about Cisco Security Management Suite are correct?()
A. It should be implemented in a management VLAN.
B. Its connection to managed devices should be over a data VLAN.
C. It is made up of Cisco Security MARS and Clean Access software.
D. It should be deployed as close to the edge of the network as possible.
E. It delivers policy administration and enforcement for the Cisco Self-Defending Network.
[多项选择]Which two statements about an interface configured with the asr-group command are correct?()
A. The FWSM supports up to 16 asymmetric routing groups.
B. If a matching packet is not found, the packet is dropped.
C. Asymetric routing of return traffic is enabled.
D. If a matching packet is found, the Layer 3 header is rewritten.
E. If a matching packet is found, the Layer 3 header is rewritten and the packet is forwarded to the default gateway.
[多项选择]Which two data intergrity algorithms are commonly used in VPN solutions?()
A. HMAC-MD5
B. RSA
C. HMAC-SHA-1
D. DH1
E. DH2
[多项选择]Which two tasks does the Dynamic Host Configuration Protocol perform?()
A. Set the IP gateway to be used by the network.
B. Perform host discovery used DHCPDISCOVER message.
C. Configure IP address parameters from DHCP server to a host.
D. Provide an easy management of layer 3 devices.
E. Monitor IP performance using the DHCP server.
F. Assign and renew IP address from the default pool.
[多项选择]Which two commands correctly verify whether port security has been configured on port FastEthernet 0/12 on a switch?()
A. SW1#show swithport port-security interface FastEthernet 0/12
B. SW1#show swithport port-secure interface FastEthernet 0/12
C. SW1#show port-secure interface FastEthernet 0/12
D. SW1#show running-config

我来回答:

购买搜题卡查看答案
[会员特权] 开通VIP, 查看 全部题目答案
[会员特权] 享免全部广告特权
推荐91天
¥36.8
¥80元
31天
¥20.8
¥40元
365天
¥88.8
¥188元
请选择支付方式
  • 微信支付
  • 支付宝支付
点击支付即表示同意并接受了《购买须知》
立即支付 系统将自动为您注册账号
请使用微信扫码支付

订单号:

请不要关闭本页面,支付完成后请点击【支付完成】按钮
恭喜您,购买搜题卡成功
重要提示:请拍照或截图保存账号密码!
我要搜题网官网:https://www.woyaosouti.com
我已记住账号密码