更多"Which spoken emergency signal would"的相关试题:
[单项选择]Which IOS command would you use to find out which networks are routed by a particular OSPF process（）
A. show ip ospf
B. show ip route
C. show ip protocols
D. show ip ospf database
E. None of the other alternatives apply
[单项选择]Which would you NOT use to report the amount of anchor chain out? Three shots（）.
A. at the water's edge
B. on deck
C. on the bottom
D. well in the water
[单项选择]Which of the following commands would you use, to configure a default route to any destination NOT found in the routing table?（）
A. Router(config)# ip default-route 0.0.0.0 255.255.255.255 s0
B. Router(config)# ip route 0.0.0.0 255.255.255.255 s0
C. Router(config)# ip default-route 0.0.0.0 0.0.0.0 s0
D. Router(config)# ip route 0.0.0.0 0.0.0.0 s0
E. Router(config)# ip route any any e0
[单项选择]Which IP address and wildcard mask would you use in your ACL to block all the hosts in the subnet 192.168.16.43/28?（）
A. 192.168.16.32 0.0.0.16
B. 192.168.16.43 0.0.0.212
C. 192.168.16.0 0.0.0.15
D. 192.168.16.32 0.0.0.15
E. 192.168.16.0 0.0.0.31
F. 192.168.16.16 0.0.0.31
[单项选择]What type of stopper would you use on a nylon mooring line? （）
A. Chain
B. Nylon
C. Manila
D. Wire
[单项选择]In which situation would the use of a static route be appropriate?（）
A. To configure a route to the first Layer 3 device on the network segment.
B. To configure a route from an ISP router into a corporate network.
C. To configure a route when the administrative distance of the current routing protocolis too low.
D. To reach a network is more than 15 hops away.
E. To provide access to the Internet for enterprise hosts.
[单项选择]Which command would you configure globally on a Cisco router that would allow you to view directly connected Cisco devices?（）
A. enable cdp
B. cdp enable
C. cdp run
D. run cdp
[单项选择]Which current would you encounter on a direct passage from London，England，to Capetown，South Africa（）.
A. Falkland Current
B. Brazil Current
C. Norway Current
D. Benguela Current
[单项选择]Which command should you use to verify what networks are being routed by a given OSPF process（）
A. show ip ospf
B. show ip route
C. show ip protocol
D. show ip ospfdatabase
E. None of the other alternatives apply
[单项选择]Which of the commands below would you enter if you wanted to see the configuration register of your router?（）
A. show boot
B. show flash
C. show register
D. show version
E. show config
[单项选择]Which command can you use to manually assign a static IPV6 address to a router interface？（）
A. ipv6 address PREFIX_1：：1/64
B. ipv6 autoconfig 2001：db8：2222：7272：：72/64
C. ipv6 autoconfig
D. ipv6 address 2001：db8：2222：7272：：72/64
[多项选择]Which interface commands would you enter on a Catalyst 2900 switch, if your goal was to bring all VLAN traffic to another directly connected switch?（）
A. Switch(config-if)# vlan all
B. Switch(config-if)# switchport trunk encapsulation dot1q
C. Switch(config-if)# switchport access vlan all
D. Switch(config-if)# switchport mode trunk
E. Switch(config-if)# switchport access vlan 303
[单项选择]Which ARPA data should you use in order to determine if a close quarters situation will develop with a target vessel? （）
A. Set and drift of the current
B. Relative track information
C. Predicted time of CPA
D. Initial range of acquisition
[单项选择]How should you signal the crane operator to use the main hoist?（）.
A. Use one hand to give any miotion signal , and place the other hand motionless in front of the hand giving the motion signal
B. Extend arm with the thumb pointing up , and flex the fingers in and out for as long as the load movement is desired
C. First tap your elbow with one hand , and then proceed to use regular signals
D. First tap the top of your head with your first , and then proceed to use regular signals
[单项选择]In which of the areas listed would you expect to find the highest salt concentration in a flash evaporator?（）
A. Distiller air ejector cooling medium
B. Saltwater heater discharge
C. First-stage internal feed box
D. Second-stage internal feed box
