更多"[单选题]A company has a small network,"的相关试题:
[单选题]
The network administrator has discovered that the power supply has failed on a switch in the company LAN
And that the switch has stopped functioning. It has been replaced with a Cisco Catalyst 295.0. series switch.
What must be done to ensure that this new switch becomes the root bridge on the network?
A. Lower the bridge priority number.
B. Change the MAC address of the switch.
C. Increase the VTP revision number for the domain.
D. Lower the root path cost on the switch ports.
E. Assign the switch an IP address with the lowest value.
[多选题]
The network administrator has been asked to give reasons for moving from ipv4. to ipv6.. what are two valid
Reasons for adopting ipv6. over ipv4.?(choose two)
A. telnet access does not require a password
B. nat
C. no broadcast
D. chanage of destination address in the ipv6. header
E. chanage of source address in the ipv6. header
F. autoconfiguration
[多选题]
Refer to the exhibit. A network associate has configured OSPF with the command:
After completing the configuration, the associate discovers that not all the interfaces are participating in
OSPF. Which three of the interfaces shown in the exhibit will participate in OSPF according to this
Configuration statement? (Choose three.)
A. FastEthernet0. /0.
B. FastEthernet0. /1.
C. Serial0./0.
D. Serial0./1..102.
E. Serial0./1..103.
F. Serial0./1..104.
[单选题]
A network interface port has collision detection and carrier sensing enabled on a shared twisted pair
Network. From this statement, what is known about the network interface port?
A. This is a 10.Mb/s switch port.
B. This is a 100.Mbs switch port.
C. This is an Ethernet port operating at half duplex.
D. This is an Ethernet port operating at full duplex.
E. This is a port on a network interface card in a PC.
[多选题]
That has been newly connected to the network. Which protocols were used during the test? (Choose two.)
A. ARP
B. CDP
C. DHCP
D. DNS
E. ICMP
[单选题]Your company has an Azure environment that contains resources in several regions. A company policy states-that administrators must only be allowed to create additional Azure resources in a region in the country where their office is located. You need to create the Azure resource that must be used to meet the policy requirement. What should you create?
A.a read-only lock
B.an Azure policy
C.a reservation
D.a management group
[单选题]The company has been developing in a big way and is gaining ________ internationally.
A. prestige
B. dedication
C. humanity
D. persecution
[单选题]"Your company has several business units. Each business unit requires 20 different Azure resources for daily operation. All the business units require the same type of Azure resources. You need to recommend a solution to automate the creation of the Azure resources. What should you include in the recommendations?"
A.virtual machine scale sets
B.Azure Resource Manager templates
C.the Azure API Management service
D.management groups
[单选题]10. Finding a job in such a bid company has always been ____his wildest dreams.
A.under
B.over
C.above
D.beyond
[单选题]
A network administrator is troubleshooing an EIGRP problem on a router and needs to confirm the IP
Addresses of the devices with which the router has established adjacency. The retransmit interval and the
Queue counts for the adjacent routers also need to be checked. What command will display the required
Information?
A. Router# show ip eigrp adjacency
B. Router# show ip eigrp topology
C. Router# show ip eigrp interfaces
D. Router# show ip eigrp neighbors
[单选题]
A network administrator is troubleshooting the OSPF configuration of routers R1. and R2.. The routers
Cannot establish an adjacency relationship on their common Ethernet link. The graphic shows the output of
The show ip ospf interface e0. command for routers R1. and R2.. Based on the information in the graphic,
What is the cause of this problem?
A. The OSPF area is not configured properly.
B. The priority on R1. should be set higher.
C. The cost on R1. should be set higher.
D. The hello and dead timers are not configured properly.
E. A backup designated router needs to be added to the network.
F. The OSPF process ID numbers must match.
[单选题]
A network administrator is verifying the configuration of a newly installed host by establishing an FTP
Connection to a remote server. What is the highest layer of the protocol stack that the nework administrator
Is using for this operation?
A. application
B. presentation
C. session
D. transport
E. internet
F. data link
[多选题]A network administrator changes the configuration register to 0.x214.2. and reboots the router. What are tworesults of making this change? (Choose two.)
A. The IOS image will be ignored.
B. The router will prompt to enter initial configuration mode.
C. The router will boot to ROM.
D. Any configuration entries in NVRAM will be ignored.
E. The configuration in flash memory will be booted.
[单选题]
Which network protocol does DNS use?
A. FTP
B. TFTP
C. TCP
D. UDP
E. SCP
[单选题]
Which command helps a network administrator to manage memory by displaying flash memory andNVRAM utilization?
A. show secure
B. show file systems
C. show flash
D. show version
[单选题]
A network administrator needs to configure a serial link between the main office and a remote location.The
Router at the remote office is a non-cisco router. How should the network administrator configure the serial
Interface of the main office router to make the connection?
A. Main(config)#interface serial 0./0.Main(config-if)#no shut
B. Main(config)#interface serial 0./0.Main(config-if)#encapsulation ietfMain(config-if)#no shut
C. Main(config)#interface serial 0./0.Main(config-if)#encapsulation frame-relayMain(config-if)#authenication chapMain(config-if)#no shut
D. Main(config)#interface serial 0./0.Main(config-if)#encapsulation pppMain(config-if)#no shut
[单选题]108 The network team introduces a new subnet 10.10.22.0/24 to the network. The route needs to be configured on the F5 device to access this network via the 30.30.30.158 gateway.
How should the LTM Specialist configure this route?
A. Tmsh modify net route 10.10.22/24 gw 30.30.30.158
B. Tmsh create net route 10.10.22/24 gw 30.30.30.158
C. Tmsh changey net route 10.10.22/24 gw 30.30.30.158
D. Tmsh add net route 10.10.22/24 gw 30.30.30.158
[单选题]
Refer to the exhibit. A network administrator needs to add a new VLAN, named VLAN3., to the network
Shown. Unfortunately, there is not another FastEthernet interface on R1. to connect to the new VLAN3..
Which approach is the most cost effective solution for this problem?
A. Purchase a new FastEthernet module and install it on R1.
B. Replace R1. with a new router that has at least three FastEthernet interfaces.
C. Configure a second switch to support VLAN3. with a VLAN trunk between SW1. and the new switch.
D. Configure a single VLAN trunk between R1. and SW1. and configure subinterface on R1. interface foreach VLAN.
E. Connect another router to a serial interface of R1.. Use a FastEthernet interface on the new router for
VLAN3..
