更多"Which two locations can be configur"的相关试题:
[多项选择]Which two locations can be configured as a source for the IOS image in the boot system command?（）
A. RAM
B. NVRAM
C. flash memory
D. HTTP server
E. TFTP server
F. Telnet server
[多项选择]Which two can be used to create and apply an export policy that advertises static routes to RIP neighbors?（）
A. set protocols rip export demo
B. edit policy-options policy-statement demo set term 1 from protocol static set term 1 then accept
C. edit policy-options policy-statement demo set term 1 from protocol static
D. set policy-options policy-statement demo
[多项选择]Which two devices can interfere with the operation of a wireless network because they operate on similar frequencies (Choose two.)（）。
A. copier
B. microwave oven
C. toaster
D. cordless phone
E. IP phone
F. AM radio
[多项选择]In which two ways can you influence how downstream LSRs treat MPLS traffic?（）
A. Use an EXP rewrite table.
B. Use a DSCP rewrite table.
C. Statically assign a CoS value to an LDP-signaled LSP.
D. Statically assign a CoS value to an RSVP-signaled LSP.
[多项选择]Which two functions can be configured on the ERX Edge Router to support MBGP? （）(Choose two.)
A. address-family ipv4 unicast
B. address-family vpnv4 unicast
C. address-family ipv4 multicast
D. address-family vpnv4 multicast
[多项选择]Which two addresses can be assigned to a host with a subnet mask of 255.255.254.0？（）
A. 113.10.4.0
B. 186.54.3.0
C. 175.33.3.255
D. 26.35.2.255
E. 17.35.36.0
[多项选择]Which two statements in a source NAT configuration are true regarding addresses, rule-sets, or rules that overlap?（）(Choose two.)
A. Addresses used for NAT pools should never overlap.
B. If more than one rule-set matches traffic, the rule-set with the most specific context takes precedence.
C. If traffic matches two rules within the same rule-set, both rules listed in the configuration are applied.
D. Dynamic source NAT rules take precedence over static source NAT rules.
[多项选择]Which two tasks can you perform using only the TO_CHAR function? （）
A. convert 10 to 'TEN'
B. convert '10' to 10
C. convert 10 to '10'
D. convert 'TEN' to 10
E. convert a date to a character expression
F. convert a character expression to a date
[多项选择]In which two ways can the router ID selection be controlled?（）
A. Manually assign rid.
B. configure local-address.
C. enable the fxp0 interface.
D. Assign nonmartian address to lo0.
[多项选择]Which two commands can be used to verify a trunk link configurationt status on a given cisco switch?（）
A. show interfaces interface
B. show interfaces interface trunk
C. show interfaces interface switchport
D. show ip interface brief
E. show interfaces vlan
