[单项选择]TestKing has 25 computers and decides to connect the network to the Internet.TestKing would like for all of the computers to have access to the Internet at the same time, but TestKing only has four usable publicly routable IP addresses.What should be configured on the router so that all computers can connect to the Internet simultaneously?（）
A. Static NAT
B. Global NAT
C. Dynamic NAT
D. Static NAT with ACLs
E. Dynamic NAT with overload

[单项选择]A technician has a PC that has no Internet connection. The IP address for the PC is 169.254.XXX.XXX. Which of the following should be checked FIRST?（）
A. DHCP settings
B. BIOS settings
C. DNS settings
D. Power settings

[单项选择]Which of the following Internet technologies has the slowest potential upload speed due toinherent latency issues?（）
A. 3G
B. 4G
C. Satellite
D. Fiber

[单项选择]A radiotelegraph message commencing with XXX has the same meaning as a message sent by the radiotelephone commencing with（）.
A. TTT
B. SOS
C. The spoken word URGENCY
D. The spoken word PAN

[多项选择]What components are required to directly connect two PCs so they are able to participate in a simple peer-to-per network?（）
A. Straight-through cable
B. Compatible network interfaces
C. Networking protocol
D. Hub
E. Crossover cable
F. router

[单项选择]Under ISPS Code the ship to which it applies has to carry（）
A. an International Ship Security Certificate
B. an International Oil Pollution Certificate
C. a Safety Management Certificate
D. an International Ballast Water Management Certificate

[单项选择]For a CEO to be successful in government, he has to
A. regard the president as the CEO.
B. take absolute control of his department.
C. exercise more power than the congressional committee.
D. become acquainted with its power structure.

[单项选择]Which part as below don’t has direct interest in the safety of shipping and the welfare of seamen（）
A. Flag State
B. Ship owner
C. Ship chandler
D. Classification society

[单项选择] A user is trying to connect their new desktop to the network but is unable to get an IP address. The technician tests the cable and finds that there are too many open pairs. Which of the following wiring standards needs to be used in the replacement cable?（）
A. 568B
B. Crossover
C. 569-A
D. 607-A

[单项选择] Router R1 uses S0/0 to connect via a T/1 to the Frame Relay servicE. Five PVCs terminate on the serial link. Three PVCs (101, 102, and 103) are configured on subinterface S0/0.1, and one each (104 and 105) are on S0/0 .2 and S0/0.3. The configuration shows no configuration related to EIGRP WAN bandwidth control, and the bandwidth command is not configured at all. Which of the following is true about how IOS tries to limit EIGRP's use of bandwidth on S0/0?（）
A. R1 limi ts EIGRP to around 250Kbps on DLCI 102
B. R1 limits EIGRP to around 250Kbps on DLCI 104
C. R1 limits EIGRP to around 150Kbps on every DLCI
D. R1 does not limit EIGRP because noWAN bandwidth control has been configured

[单项选择]Your company has computers in multiple locations that use IPv4 and IPv6. Each location is protected by a firewall that performs symmetric NAT. You need to allow peer-to-peer communication between all locations. What should you do？ （）
A. Configure dynamic NAT on the firewall.
B. Configure the firewall to allow the use of Teredo.
C. Configure a link local IPv6 address for the internal interface of the firewall.
D. Configure a global IPv6 address for the external interface of the firewall.

[单项选择]Which of the following cable types has a MAXIMUM transmission speed of 10Mbps?（）
A. CAT6
B. CAT5
C. Single-mode fiber
D. CAT3

[单项选择] Router R1 currently has no configuration related to IPv6 or IPv4. The following configuration exists in a planning document, intended to be used to copy/paste into Router R1 to enable OSPFv3 on interfaces F0/0 and S0/0/0. No other related configuration exists. Assuming F0/0 and S0/0/0 reach an up/up state, which of the following is true about OSPFv3 on R1 after this configuration has been pasted into R1?（） ipv6 router ospf 1 ipv6 unicast- routing interface f0/0 ipv6 address 2000 ::1/64 ipv6 ospf 1 area 1 interface s0/0/0 ipv6 address 2001::/64 eui - 64 ipv6 ospf 1 area 0
A. OSPF works on F0/0 and S0/0/0 without further configuration
B. OSPF works with the addition of one command: a no shutdown command in OSPF router configur ation modE
C. OSPF works with the addition of one command: an router - id command in OSPF router configuration modE
D. OSPFv3 needs at least two more configuration commands before it works on R1

[单项选择]A cisco router is booting and has just completed the POST process.It is now ready to find and load an IOSimage.what function does the router perform next?（）
A. It checks the configuration register
B. It attempts to boot from a TFTP server
C. It loads the first image file in flash memory
D. It inspects the configuration file in NVRAM for boot instructions

[单项选择]Your network administrator has asked you to view the real-time interface usage on ge-0/0/0.Which command whould be used?（）
A. monitor interface ge0/0/0
B. traceoptions interface ge-0/0/0
C. debug interface ge0/0/0
D. monitor usage ge-0/0/0