更多"A technician installs a new sound c"的相关试题:
[单项选择]A technician installs a new video card in a desktop with onboard video. The technician boots the unit but sees no display. The monitor power light is on and the OS seems to be loading. Which ofthe following is the MOST likely cause?（）
A. The display is defective.
B. The video card needs to be flashed.
C. The internal adapter has not been disabled.
D. The new video card is defective.
[单项选择]After a technician installs a video card, which of the following should the technician configure NEXT?（）
A. Resolution
B. Colors
C. Dots per inch
D. Refresh rate
[单项选择]After a technician installs a new CMOS battery on a motherboard, which of the following will thetechnician have to change? （）
A. Firmware version
B. System date/time
C. Bus speeds
D. Jumper settings
[单项选择]A technician installs a local web server which is not accessible from the network. Which of the following is the local IP address that the web server should be using on the loopback adapter?（）
A. 127.0.0.1
B. 172.31.146.1
C. 192.168.1.1
D. 10.1.1.1
[单项选择]A technician installs a CD-RW drive with a feature that enables the drive to write labels directly onto the disk. The computer will burn disks but will not write labels. Which of the following should the technician do NEXT?（）
A. Reboot the computer
B. Remove the drive and reinstall
C. Install the device driver
D. Flash the BIOS
[简答题]A good way of learning to make the sound of a new language is to use recordings which have paused after each sentence giving you time to say what have learnt before the next sentence comes．
[单项选择]A technician installs a SATA controller card and moves the hard drive cable from the system board to the SATA controller. The system POSTs and the controller BIOS recognizes the hard drive but does not boot to the hard drive and start Windows. Which of the following is the MOST likely cause of the problem？（）
A. Windows cannot be booted from a controller card.
B. The hard drive must have Windows reinstalled because a new controller card was installed.
C. The SATA controller card was not set as a boot device in the computer BIOS.
D. The new controller must have the correct jumper settings for Windows mode.
[单项选择] While installing a new PCI card the administrator touched the motherboard. While powering on the server, a series of beeps were emitted and the server did not POST. Which of the following could be done to prevent this problem?（）
A. Use ESD equipment.
B. Verify correct voltages are being supplied.
C. Use a system board tester to check for compatibility issues.
D. Install compatible PCI cards
[单项选择]An administrator installs a new network card in a properly functioning DC. During the Windows boot up process the DC bluescreens. Which of the following is the NEXT step?（）
A. Press F8 and boot to Directory Services Restore Mode.
B. Press F8 and boot to Last Known Good Configuration.
C. Reboot the server again.
D. Press F8 and boot to Safe Mode.
[单项选择]The new Greenpeace card breaks down in a few months.
[单项选择]The new credit card that is being introduced by Greenpeace is net made of plastic.
[单项选择]After installing a new video card, the computer loads Windows and continuously reboots. Which of the following would be the FIRST step that a technician should take?（）
A. Run CHKDSK
B. Boot to ERD
C. Run MSCONFIG
D. Go into Safe Mode
[单项选择]When installing a new PCIe network card, when should manufacturer software and drivers beinstalled?（）
A. Before inserting the PCIe network card in the case
B. After inserting the new PCIe network card in the case
C. They will be automatically loaded after installation
D. Load them concurrently with the PCIe network card
[单项选择]In the sentence "In spoken languages units of sound and meaning are combined sequentially.", the word "sequentially" can be replaced by_____.
A. separately
B. together
C. consequently
D. subsequently
[单项选择]Dubbing is used in filmmaking ____ a new sound track to a motion picture.
A. which to add
B. to add
C. is adding that
D. to add while
[单项选择] A technician installed a new video card on a motherboard which has onboard video. When the monitor was plugged into the new card and the power was turned on, a no signal message appeared on the monitor. Which of the following is MOST likely the issue?（）
A. In the BIOS, the onboard video adapter must be disabled.
B. The video resolution is set too high.
C. The LCD panel is defective.
D. The drivers for the new video card must be installed before installing the card.
[单项选择]A light sleeper is usually very ______ to any sound even as inaudible as the humming of a mosquito.
A. acute
B. keen
C. alert
D. immune
[单项选择]ECHO: SOUND
A. reflection: light
B. microphone: hearing
C. conservation: talk
D. implication: tone
