更多"Which interface is used for RTO syn"的相关试题:
[多项选择]A router with a serial interface will be used for an ISDN link.What other function group devices are required to complete the connection to the service provider? ()
A. TE1
B. TE2
C. TA
D. NT1
E. NT2
[单项选择]Which option is true regarding the synchronization rule ?()
A. Do not use or internally advertise a route until the route is lear ned from a source other than BGP.
B. Do not use or advertise a route until the route is learned from a BGP peer.
C. Do not use or advertise routes marked PARTIAL.
D. Wait until a CONFIRM message is received before using routes from BGP neighbors.
[单项选择]Which interface is used to configure debug parameters for log files?()
A. Datastore Control Center
B. Alarm and Trace Configuration
C. Custom File Configuration
D. Control Center
[单项选择]A Router with a BRI/T interface will be used for an ISDN Connection what other ISDN device is required to complete this connection? ()
A. TE1
B. TE2
C. NT1
D. NT2
[多项选择]Which two routing interface parameters are supported in OSPF implementations?()
A. retransmit - interval
B. de ad - interval
C. stub area
D. virtual link
E. NSSA area
[单项选择]Which of the following storage interface protocols has the FASTEST speeds?()
A. Ultra2 SCSI
B. SA TA
C. Ultra320 SCSI
D. SAS
[单项选择]Which interface tunnel parameter allows an LSP to use a specified explicit route?()
A. path-option
B. route-option
C. explicit-path-option
D. explicit-route-option
[单项选择]Which interface does the Infranet Controller use to push the configuration? ()
A. trusted port
B. internal port
C. trust interface
D. untrust interface
[多项选择]Which two statements about an interface configured with the asr-group command are correct?()
A. The FWSM supports up to 16 asymmetric routing groups.
B. If a matching packet is not found, the packet is dropped.
C. Asymetric routing of return traffic is enabled.
D. If a matching packet is found, the Layer 3 header is rewritten.
E. If a matching packet is found, the Layer 3 header is rewritten and the packet is forwarded to the default gateway.
[单项选择]Which interface type connects the control and forwarding planes on an MX Series device?()
A. fxp1
B. fxp0
C. me0
D. ae1
[多项选择]Which two statements are true regarding interface properties? ()
A. MTU and speed must be configured under each unit.
B. Physical parameters such as MTU, duplex mode, and speed are configured under the interface name.
C. IP and IPv6 addresses are configured under a unit-number.
D. DLCI numbers, VPI/VCI values, and VLAN tags are physical parameters.
[单项选择]Which IBM tape interface architecture has the best performance and distance characteristics? ()
A. SAS
B. SCSI
C. ESCON
D. Fibre Channel
[多项选择]Which interface commands would you enter on a Catalyst 2900 switch, if your goal was to bring all VLAN traffic to another directly connected switch?()
A. Switch(config-if)# vlan all
B. Switch(config-if)# switchport trunk encapsulation dot1q
C. Switch(config-if)# switchport access vlan all
D. Switch(config-if)# switchport mode trunk
E. Switch(config-if)# switchport access vlan 303
[单项选择]Which message is used to transport routing information between BGP peers?()
A. Open
B. Active
C. Update
D. Keepalive
[单项选择]Which protocol is used for communication between the Junos Pulse client and 802.1X-compliant switches when performing Layer 2 enforcement?()
A. EAP
B. RADIUS
C. SSL
D. EAP-o-HTTP
[单项选择]Which command is used to initialize and configure a NIM master?()
A. /usr/sbin/nim_init
B. /usr/bin/installnim
C. /usr/sbin/nimconfig
D. /usr/sbin/setup_server
[单项选择]which command is used to enable CHAP authentication whit PAP as the fallback method on a serial interface?()
A. (config-if)#authentication ppp chap fallback ppp
B. (config-if)#authentication ppp chap pap
C. (config-if)#ppp authentication chap pap
D. (config-if)#ppp authentication chap fallback ppp