更多"Which two design concerns must be a"的相关试题:
[多项选择]Which three security concerns can be addressed by a tunnel mode IPSec VPN secured by AH?（）(Choose three.)
A. data integrity
B. data confidentiality
C. data authentication
D. outer IP header confidentiality
E. outer IP header authentication
[单项选择]Which parameters must you select when configuring operating system probes SCREEN options?（）
A. syn-fin, syn-flood, and tcp-no-frag
B. syn-fin, port-scan, and tcp-no-flag
C. syn-fin, fin-no-ack, and tcp-no-frag
D. syn-fin, syn-ack-ack-proxy, and tcp-no-frag
[多项选择]In a collapsed core design, which two benefits are provided by a second-generation Cisco MDS director（）
A. a higher fan-out ratio
B. fully redundant switches
C. 100 percent port efficiency
D. allI S Lscontained with inasingle chass is
E. higher latency and through put than acore-edged esign switch
[单项选择]Which of the following must occur when installing SCSI devices into the server?（）
A. Terminate the back end of the chain.
B. Set the jumper to device ID 0.
C. Terminate both ends of the chain.
D. Set the jumper to cable select.
[多项选择]Which two considerations must you take into account when deploying a Junos Pulse Access Control Service cluster?（）
A. State synchronization occurs only through the internal network interface card (NIC)
B. Latency of the WAN must be less than 300 ms.
C. Authenticating endpoints must be on the same LAN segment.
D. Cluster members must use the same hardware platfor
[多项选择]Which two design recommendations are most appropriate when OSPF is the data center core routing protocol? （）
A. Never use passive interfaces.
B. Use NSSA areas from the core down.
C. Use totally stub areas to stop type 3 LSAs.
D. Use the lowest Ethernet interface IP address as the router ID.
E. Tune OSPF timers to enable OSPF to achieve quicker convergence.
[多项选择]Which two settings must be configured in order to use the GUI to configure Call Admission Control with voice applications?（）
A. QoS must be set to Platinum
B. WMM must be enabled
C. QoS must be set to Gold
D. TSPEC must be disabled
E. Cisco Compatible Extensions must be disabled
[多项选择]Which three elements must be used when you configure a router interface for vlan trunking?（）
A. one IP network or subnetwork for each subinterface
B. subinterface numbering that matches vlan tages
C. subinterface encapsulation identifiers that match vlan tags
D. a management domain for each subinterface
E. one physical interface for each subinterface
F. one subinterface per vlan
[多项选择]Which two steps are needed when configuring multiple RPs using MSDP within a single PIM domain? （）
A. Configure a non-unique address on the loopback interface for use by the PIM RP.
B. Configure MSDP with the unique address (router ID) as the local address of the peer.
C. Configure MSDP with the non-unique address (router ID) as the local address of the peer.
D. Configure a unique address on the loopback interface, used as the PIM RP.
[多项选择]Which two benefits are provided when Cisco enterprise solutions are employed across all placesin the network? （）(Choose two.)
A. regular upgrade process
B. multivendor support
C. cost savings
D. product variety
E. well-tested interoperability
[多项选择]Which two are correct when configuring an IP address for a Fast Ethernet interface?（）
A. set interfaces fe-0/0/0 address 10.1.1.1/24
B. set interfaces fe-0/0/0.0 family inet address 10.1.1.1/24
C. set interfaces fe-0/0/0.0 address 10.1.1.1/24
D. set interfaces fe-0/0/0 unit 0 family inet address 10.1.1.1/24
[多项选择]Which two statements apply when a user has entered private configuration mode by typing configure private?（）
A. All users have their own active configuration
B. All users have their own private candidate configuration
C. When a user commits, all non conflicting changes made by all users are commited
D. When a users commits, only the user's own changes are commited
