更多"An administrator is configuring one"的相关试题:
[单项选择]When configuring more than one archival site, which statement is true?（）
A. The system will first attempt the transfer using the URL configured last
B. The system will transfer the configuration to each archival site
C. The system will not transfer to a secondary site unless the previous site fails
D. The system will transfer using secure copy protocol (SCP) before attempting FTP
[多项选择] An administrator is configuring a Catalyst switch with VLAN information that must be automatically distributed to other Catalyst switches in the network. What conditions must be met in order for the VLANs configured on this switch to be automatically configured on the other switches?（）
A. The switch that will share its VLAN configuration must be in VTP server mode.
B. The switches must be in the same VTP domain.
C. The switch that will share the VLAN information must be configured as the root bridge.
D. The switches must be connected over VLAN trunks.
E. The switches must be configured to use the same STP version.
F. The switches must have VTP pruning activated.
[单项选择] An administrator is configuring an LPAR for a NIM installation and is unsure if the 'Ping Test' option within SMS is a required configuration step. Which statement best describes the 'Ping Test' option?（）
A. The 'Ping Test' is a recommended step to verify the IP information entered into the RIPL SMS panel.
B. The 'Ping Test' is a mandatory step required to commit the IP information entered into the RIPL SMS panel.
C. The 'Ping Test' is an optional step to verify network configuration entered into the RIPL SMS panel on older copper-based networks.
D. The 'Ping Test' is an optional step to verify network connectivity between client and server, where ICMP traffic is allowed on the connecting network.
[多项选择]A network administrator is configuring ACLs on a cisco router,to allow traffic from hosts on networks 192.168.146.0,192.168.147.0,192.168.148.0and192.168.149.0 only.Which two ACL statements when combined are the best for accomplishing the task?（）
A. access-list 10 permit ip 192.168.147.0 0.0.0.255.255
B. access-list 10 permit ip 192.168.149.0 0.0.0.255.255
C. access-list 10 permit ip 192.168.146.0 0.0.0.0.255
D. access-list 10 permit ip 192.168.146.0 0.0.0.1.255
E. access-list 10 permit ip 192.168.148.0 0.0.0.1.255
F. access-list 10 permit ip 192.168.146.0 255.255.255.0
[单项选择]An administrator is configuring IP 10.178.1.5 on a legacy device that will only accept a classfuladdress. Which of the following is the address that can be used in this scenario?（）
A. 10.178.1.5/1
B. 10.178.1.5/8
C. 10.178.1.5/16
D. 10.178.15/30
[多项选择]You are configuring an LDAP authentication server, and you want to configure role-mapping rules based on group membership. When you attempt to search for groups in the server catalog, no groups appear.Assuming the LDAP server is reachable and functioning properly, in the admin GUI. Which two parts of the configuration should you verify are correct?（）
A. Finding user entries
B. Authentication required
C. LDAP Server Type
D. Determining group membership
[多项选择]When configuring a DHCP server, which of the following can the administrator define for DHCP users?（）
A. Database server
B. NTP server
C. DHCP server
D. SQLServer
E. DNS server
F. Domain name
[单项选择]A system administrator boots a server in normal mode, the boot process displays and LED 551 and stops. LED 551 indicates the root volume group is being varied on. All of the following are probable causes of the problem EXCEPT:（）
A. The bosboot command failed to complete.
B. The JFS log device is corrupted.
C. The initttab file is corrupted.
D. The /dev entries or /etc files are missing.
[单项选择] A new server was installed for the purpose of monitoring network traffic. The network has been configured in such a way that all traffic will be mirrored out the port this server is connected to. When reviewing the network traffic logs on the server only traffic destined to the server is listed in the logs. Which of the following is preventing the server from seeing all network traffic?（）
A. NIC filtering is enabled.
B. Port security is configured.
C. NIC is not in promiscuous mode.
D. NIC is in promiscuous mode.
[单项选择] An administrator only has one public IP address that must be shared among five employees. Which of the following network schemes should be used?（）
A. SNAT
B. SNAP
C. NAC
D. MPLS
[单项选择]A system administrator notices that one of the mirrored disks, hdisk7 on datavg, has had a hardware failure. What is the best method of recover without causing additional problems?（）
A. unmirrorvg datavg hdisk7 reducevg datavg hdisk7 replace the physical volume, run cfgmgr extendvg datavg hdisk7 mirrovg datavg hdisk7
B. varyoffvg datavg Rmdev -l hdisk7 -d Replace the physical volu,e run cfgmgr The system will automatically remirror when the disk is replaced
C. unmirrorvg datavg hdisk7 rmdev -l hdisk7 - d replace the physical volume, run cfgmgr extendvg datavg hdisk7 The system will automatically remirror when the disk is replaced.
D. unmirrorvg datavg hdisk7 reducevg data hdisk7 rmdev -l hdisk7 -d replace the physical volume, run cfgmgr extendvg datavg hdisk7 mirrovg datavg
[单项选择]An administrator is installing Windows Server 2003 via CD on a new server with an SAS RAID array. When the administrator reaches the option to select the target installation drive, there are no drives listed. Which of the following is the FIRST thing the administrator should do?（）
A. Restart the installation via WDS.
B. Shut down the server and check that all RAID drives are connected properly.
C. Restart the installation from CD and press F6 to install RAID drivers.
D. Go into the BIOS and set all RAID drives to compatibility mode
[单项选择]An administrator is running proprietary server software that requires services to be reconfigured every time the server is upgraded to the latest vendor version. Which of the following is the BEST solution to address this problem?（）
A. The current system configuration should be documented for future use.
B. Server diagramming and environmental topologies should be documented.
C. A copy of the latest pre-installation plan should be developed and utilized.
D. Vendor support should be contacted so that they can correct the issue.
[单项选择] An administrator is configuring a PowerHA cluster consisting of two nodes across two physical Power systems，570-1 and 570-2. Node1 is an LPAR on 570-1Node2 is an LPAR on 570-2. Dev1 is an LPAR on 570-2 （this LPAR is not part of the cluster）. The cluster will manage a single resource group， RG1， with a single application server， APP1. The resourcegroup will have a home node of Node1. Node1 is configured with 4.0 CPU desired， 0.4 minimum， 4.0 maximum， and 4 virtual processorsNode2 isconfigured with 0.4 CPU desired， 0.4 minimum， 4.0 maximum， and 4 virtual processors Dev1 is configuredwith 4.0 CPU desired， 0.4 minimum， 4.0 maximum， and 4 virtual processors When the resource group RG1 is acquired by Node2 the administrator would like to dynamically move 3.6processor entitlement units from Dev1 to Node2. How could the administrator achieve this in the PowerHAcluster？（）
A. Create a custom event script to perform the change to CPU entitlement
B. Modify the extended performance tuning parameters for the cluster to modify CPU entitlement uponresource group acquisition
C. Customize the resource group attributes of RG1 so that the CPU entitlement is modified for Node2 uponresource group acquisition
D. Customize the application server attributes of APP1 so that the CPU entitlement is modified for Node2upon resource group acquisition
[单项选择]An administrator identifies that a server is shutting down. The administrator powers up the server and OS loads but after a few minutes it powers down again. Which of the following is the cause?（）
A. Redundant power supply failure
B. CPU overheating
C. Memory failure
D. Hard disk failure
[多项选择]An administrator is configuring one server to monitor hardware level information on a second Windows server. Which of the following should be setup on the Windows server to allow the monitoring server to access this information？ （）
A. WMI
B. RIS
C. DNS
D. SNMP
E. SMTP
