[单项选择] A new server was installed for the purpose of monitoring network traffic. The network has been configured in such a way that all traffic will be mirrored out the port this server is connected to. When reviewing the network traffic logs on the server only traffic destined to the server is listed in the logs. Which of the following is preventing the server from seeing all network traffic?（）
A. NIC filtering is enabled.
B. Port security is configured.
C. NIC is not in promiscuous mode.
D. NIC is in promiscuous mode.

[单项选择] You have just installed a new web server on the Testking network. You are required to ensure that the web server is accessible from the Internet. The network uses private addressing, so an IP-to-registered address mapping is required.To do this, you enter the following command:TestKing(config)# ip nat inside source static 192.168.2.1 198.18.1.254 You unsuccessfully try to ping the Internet from a PC host on the LAN. During the troubleshooting process, you enter the "show ip nat translations" command but the output is blank. What is the most likely cause of the problem?（）
A. The keyword overload is missing from the command.
B. The NAT pool must be defined first.
C. An access list must be defined to create static NAT translations.
D. The interfaces must be configured for NAT.
E. None of the above

[多项选择]An administrator is configuring one server to monitor hardware level information on a second Windows server.Which of the following should be setup on the Windows server to allow the monitoring server to access this information?（）
A. WMI
B. RIS
C. DNS
D. SNMP
E. SMTP

[单项选择] A new server was installed. Most clients are located in the same subnet as the server and can successfully access the server. Clients located on different subnets have been unable to access the server, but have no trouble accessing other servers on their subnet. Which of the following is the reason that these clients are unable to access the server?（）
A. DHCP has assigned the wrong addresses.
B. Incorrect default gateway on the server.
C. DNS entries were not created.
D. WINS server is not responding.

[单项选择]The purpose of the new economic policy is not to hinder economic growth______ to guide it in a beneficial way.
A. and
B. as
C. but
D. nor

[单项选择]The purpose of the New Deal measures was to（）
A. save American democracy and the capitalist system
B. check the worsening of the economic situation
C. help people tie over the difficulty
D. increase American export

[单项选择] An administrator has just installed a web server for the company's Internet site. After bringing the system online, customers notify the administrator that they cannot connect to the server. The administrator tests the web server from a workstation and can access the website. The customers continue to report issues. Which of the following is the MOST likely reason for this?（）
A. The server's firewall is misconfigured.
B. The server's timeout feature is set incorrectly.
C. The web server was not installed properly.
D. The company firewall is misconfigured.

[单项选择] A new server was installed for the purpose of monitoring network traffic. The network has been configured in such a way that all traffic will be mirrored out the port this server is connected to. When reviewing the network traffic logs on the server only traffic destined to the server is listed in the logs. Which of the following is preventing the server from seeing all network traffic？ （）
A.  NIC filtering is enabled.
B.  Port security is configured.
C.  NIC is not in promiscuous mode.
D.  NIC is in promiscuous mode.

[单项选择] A new server was installed. Most clients are located in the same subnet as the server and can successfully access the server. Clients located on different subnets have been unable to access the server， but have no trouble accessing other servers on their subnet.  Which of the following is the reason that these clients are unable to access the server？（）
A.  DHCP has assigned the wrong addresses.
B.  Incorrect default gateway on the server.
C.  DNS entries were not created.
D.  WINS server is not responding.

[单项选择] A technician installed a new wireless access point on an existing small office home office (SOHO) network with a selective security option enabled. All wireless computers connect to the new network except one computer that cannot connect to the wireless network. Which of the following is the cause?（）
A. The network uses MAC filtering
B. The network uses WEP
C. The network uses SSID broadcast
D. The network uses WPA

[单项选择]An administrator recently installed a new array controller into a server. When the server is running POST the controller does not appear as present. Which of the following could be the reason for this?（）
A. The server BIOS firmware is out-of-date.
B. The server does not have the correct drivers.
C. The server hard drives have not begun to spin.
D. The server has too little memory installed.

[单项选择]A system administrator installed a new switch using a script to configure it. IP connectivity was tested using pings to SwitchB. Later attempts to access NewSwitch using Telnet from SwitchA failed. Which statement is true?（）
A. Executing password recovery is required.
B. The virtual terminal lines are misconfigured.
C. Use Telnet to connect to RouterA and then to NewSwitch to correct the error.
D. Power cycle of NewSwitch will return it to a default configuration.

[单项选择]A technician recently installed a new firewall. Which of the following ports must be open to permit HTTPS traffic?（）
A. 21
B. 23
C. 80
D. 443

[单项选择]A technician installed a new motherboard in a workstation. Which of the following describes theBEST steps for a proper installation?（）
A. Install the OS, the application software and then hardware drivers.
B. Install the chipset driver, the OS and then the hardware drivers.
C. Install the hardware drivers, the chipset driver and then the OS.
D. Install the OS, the chipset driver and then the hardware drivers.

[多项选择]A technician installed a new application on a Windows XP desktop. After the application wasinstalled, the technician rebooted the desktop and received a bluescreen error. Which of thefollowing steps should the technician perform?（） (Select TWO).
A. Boot into Safe Mode
B. Replace the motherboard
C. Uninstall the application
D. Replace the hard drive
E. Install more RAM

[单项选择]An administrator has just installed a new NIC into the server. The system POSTs fine and the NIC is recognized by the OS, but it does not receive an IP address. Which of the following is the MOST likely cause of this?（）
A. The NIC is not on the HCL.
B. The driver is incorrect on the server.
C. The patch cable has not been seated properly.
D. The NIC is not seated properly.

[单项选择]A technician has just installed a new power supply into a desktop computer and now the computer will not turn on. Which of the following is the MOST likely cause?（）
A. The voltage selector switch on the power supply is set incorrectly.
B. The 3.3v power line is connected to the wrong input on the motherboard.
C. The new power supply voltage rating is too high.
D. The 12v power cord is installed incorrectly.

[单项选择]A technician has installed a new motherboard in a workstation, but after hardware tests, themotherboard has failed. Which of the following should the technician do FIRST before replacingthe motherboard? （）
A. Reseat all power connections.
B. Remove the CMOS battery.
C. Install the graphics card.
D. Ground to the case.