更多"A technician recently installed a n"的相关试题:
[单项选择] A technician installed a new wireless access point on an existing small office home office (SOHO) network with a selective security option enabled. All wireless computers connect to the new network except one computer that cannot connect to the wireless network. Which of the following is the cause?（）
A. The network uses MAC filtering
B. The network uses WEP
C. The network uses SSID broadcast
D. The network uses WPA
[单项选择]A technician installed a new motherboard in a workstation. Which of the following describes theBEST steps for a proper installation?（）
A. Install the OS, the application software and then hardware drivers.
B. Install the chipset driver, the OS and then the hardware drivers.
C. Install the hardware drivers, the chipset driver and then the OS.
D. Install the OS, the chipset driver and then the hardware drivers.
[多项选择]A technician installed a new application on a Windows XP desktop. After the application wasinstalled, the technician rebooted the desktop and received a bluescreen error. Which of thefollowing steps should the technician perform?（） (Select TWO).
A. Boot into Safe Mode
B. Replace the motherboard
C. Uninstall the application
D. Replace the hard drive
E. Install more RAM
[单项选择] A technician installed a new video card on a motherboard which has onboard video. When the monitor was plugged into the new card and the power was turned on, a no signal message appeared on the monitor. Which of the following is MOST likely the issue?（）
A. In the BIOS, the onboard video adapter must be disabled.
B. The video resolution is set too high.
C. The LCD panel is defective.
D. The drivers for the new video card must be installed before installing the card.
[单项选择]A technician has installed a new motherboard in a workstation, but after hardware tests, themotherboard has failed. Which of the following should the technician do FIRST before replacingthe motherboard? （）
A. Reseat all power connections.
B. Remove the CMOS battery.
C. Install the graphics card.
D. Ground to the case.
[单项选择]A technician has just installed a new power supply into a desktop computer and now the computer will not turn on. Which of the following is the MOST likely cause?（）
A. The voltage selector switch on the power supply is set incorrectly.
B. The 3.3v power line is connected to the wrong input on the motherboard.
C. The new power supply voltage rating is too high.
D. The 12v power cord is installed incorrectly.
[单项选择] After a technician came out and installed a new wireless router, one of the wired workstations began having problems connecting to the file server. This is only an intermittent problem. Which of the following actions will the technician MOST likely perform to resolve this problem?（）
A. Change the router's SSID
B. Move the router's location
C. Check user permissions
D. Check the cable ends
[单项选择]An administrator recently installed a new array controller into a server. When the server is running POST the controller does not appear as present. Which of the following could be the reason for this?（）
A. The server BIOS firmware is out-of-date.
B. The server does not have the correct drivers.
C. The server hard drives have not begun to spin.
D. The server has too little memory installed.
[单项选择]Recently three new applications were installed on all the desktops in a company branch. One of the applications causes Windows to crash on startup, but the technician is unable to find out which application it is. Without removing all three applications, which of the following is the BEST way to determine the cause of the crash?（）
A. Launch REGEDIT and remove the offending applications from the Run key.
B. Start the computer in Safe Mode and check Event Viewer.
C. Put in the ERD and when the window pops up select the option for Repair Broken Links and Applications.
D. Hit the F6 key as Windows loads and run Repair Broken Links and Applications.
[单项选择]A technician has installed Windows Vista Ultimate and is setting up the Media Center. When the technician goes to watch TV, Media Center displays an error of no TV tuner installed. The TV tuner is installed with the correct drivers. Which of the following is the solution to the problem?（）
A. TV tuner codec was not installed.
B. Not enough RAM to support the TV tuner.
C. Motherboard is faulty.
D. Video card drivers are not installed.
[单项选择]A technician just installed an antivirus suite on a workstation. It is kept up-to-date and has recently scanned the system. A day later the user reports slower response times than usual. Which of the following is the user MOST likely experiencing?（）
A. Advertisements
B. Resource consumption
C. A trojan infection
D. Unremoved viruses
[单项选择] A technician has installed a secondary hard drive for a computer. However, the hard drive is not appearing under My Computer. The disk is receiving power, and appeared on the POST when Windows started. Which of the following Windows utilities would help configure the new hard disk?（）
A. Disk Management
B. Services and Applications
C. Removable Storage
D. Device Manager
[单项选择]After a technician installs a new CMOS battery on a motherboard, which of the following will thetechnician have to change? （）
A. Firmware version
B. System date/time
C. Bus speeds
D. Jumper settings
[单项选择]A technician installs a new sound card but no sound can be heard. Which of the following utilities can be used to see an error?（）
A. MSCONFIG
B. Device Manager
C. DXDIAG
D. REGEDIT
[单项选择]A technician installs a new video card in a desktop with onboard video. The technician boots the unit but sees no display. The monitor power light is on and the OS seems to be loading. Which ofthe following is the MOST likely cause?（）
A. The display is defective.
B. The video card needs to be flashed.
C. The internal adapter has not been disabled.
D. The new video card is defective.
[单项选择] A new processor was recently installed on a one year old motherboard, replacing the original processor. The processor is on the motherboard’s supported processor list and was double checked for proper installation. However, the PC refuses to POST properly and displays no video onscreen. Which of the following is the MOST likely issue?（）
A. Too much thermal paste was used on the processor and it is preventing boot.
B. The motherboard needs to have its PWD jumper removed before the first boot.
C. The motherboard needs to have the most recent BIOS version installed.
D. The motherboard needs to have a newer CMOS chip installed.
[单项选择]A system administrator installed a new switch using a script to configure it. IP connectivity was tested using pings to SwitchB. Later attempts to access NewSwitch using Telnet from SwitchA failed. Which statement is true?（）
A. Executing password recovery is required.
B. The virtual terminal lines are misconfigured.
C. Use Telnet to connect to RouterA and then to NewSwitch to correct the error.
D. Power cycle of NewSwitch will return it to a default configuration.
