[单项选择] A technician needs to add network capacity. However, when plugging a second switch into the first switch, there is no link light. Which of the following is the cause of this situation?（）
A. The switches are not stackable
B. The cable was not wired using 568A
C. The cable needs to be a crossover cable
D. The switches have IGMP snooping enabled

[单项选择] A network administrator needs to add an additional connection to a room. The administrator adds a new Ethernet switch and must connect it to an existing switch. Which cable type should be used to connect the two switches?（）
A. CAT3 cable
B. Serial cable
C. Crossover cable
D. Rollover cable

[单项选择]A technician at TestKing needs to update the network documentation. One of the tasks includes documenting the name of the IOS image file of each router in the network.Which commands could be used to find this information?（）
A. Router# show protocols
B. Router# show version
C. Router# show image
D. Router# show IOS
E. Router# show flash

[单项选择]The technician needs to map a network share to the user’s Windows 7 computer from thecommand prompt. Which of the following commands will the technician execute?（）
A. NET SEND
B. NET CONFIG
C. NET USE
D. NET NAME

[单项选择]A technician needs to find an end of a network cable drop. Which of the following tools would the technician use?（）
A. Cable tester
B. Multimeter
C. Toner probe
D. Loopback plug

[单项选择]A network administrator needs to verify that switch interface 0/5 has been assigned to the Sales VLA.N. Which command will accomplish this task?（）
A. Show vlan
B. Show mac-address-table
C. Show vtp status
D. show spanning-tree root
E. show ip interface brief

[单项选择]A network administrator needs to configure a router for a Frame Relay connection to a non-Cisco router. Which of the following commands will prepare the WAN interface for this connection?（）
A. Router(config-if)# encapsulation frame-relay q933a
B. Router(config-if)# encapsulation frame-relay ansi
C. Router(config-if)# encapsulation frame-relay ietf
D. Router(config-if)# encapsulation frame-relay isl
E. None of the above

[单项选择]The network administrator needs to address seven LANs. RIP version 1 is the only routing protocol in use on the network and subnet 0 is not being used. What is the maximum number of usable IP addresses that can be supported on each LAN if the organization is using one class C address block?（）
A. 8
B. 6
C. 30
D. 32
E. 14
F. 16

[单项选择]A network administrator needs to configure a serial link between the main office and a remote location.The router at the remote office is a non-cisco router. How should the network administrator configure the serial interface of the main office router to make the connection?（）
A. Main(config)#interface serial 0/0  Main(config-if)#ip address 172.16.1.1 255.255.255.252  Main(config-if)#no shut
B. Main(config)#interface serial 0/0  Main(config-if)#ip address 172.16.1.1 255.255.255.252  Main(config-if)#encapsulation ietf Main(config-if)#no shut
C. Main(config)#interface serial 0/0  Main(config-if)#ip address 172.16.1.1 255.255.255.252  Main(config-if)#encapsulation frame-relay  Main(config-if)#authenication chap Main(config-if)#no shut
D. Main(config)#interface serial 0/0  Main(config-if)#ip address 172.16.1.1 255.255.255.252   Main(config-if)#encapsulation ppp Main(config-if)#no shut

[多项选择]A network administrator needs to configure port security on a switch.which two statements are true?（）
A. The network administrator can apply port security to dynamic access ports
B. The network administrator can configure static secure or sticky secure mac addresses in the voice vlan.
C. The sticky learning feature allows the addition of dynamically learned addresses to the running configuration.
D. The network administrator can apply port security to EtherChannels.
E. When dynamic mac address learning is enabled on an interface,the switch can learn new addresses,up to the maximum defined.

[单项选择]A network administrator needs to force a high-performance switch that is located in the MDF to become the root bridge for a redundant path switched network. What can be done to ensure that this switch assumes the role as root bridge（）。
A. Establish a direct link from the switch to all other switches in the network.
B. Assign the switch a higher MAC address than the other switches in the network have.
C. Configure the switch so that it has a lower priority than other switches in the network.
D. Configure the switch for full-duplex operation and configure the other switches for half-duplex operation.
E. Connect the switch directly to the MDF router, which will force the switch to assume the role of root bridge.

[单项选择]A technician temporarily needs an additional network connection in their office to test a newworkstation. Which of the following is the BEST solution to add a temporary network connection?（）
A. Install a small network switch
B. Use port mirroring on the switch
C. Split the pairs of the existing jack
D. Install a CSU/DSU

[单项选择]A network technician is troubleshooting a network issue that has just been reported. Which of thefollowing troubleshooting steps should the technician take FIRST to help resolve this issue?（）
A. Record the solution in the appropriate logs for future use.
B. Ask the user who reported the issue what past documentation they have.
C. Ask the user who reported the issue to explain the symptoms in detail.
D. Record what steps should be taken to resolve the issue.

[单项选择]Bob, a technician, needs to backup a user’s local My Documents on a Windows XP workstation.Which of the following is the QUICKEST way to the user’s folder?（）
A. Browse to the root, Documents and Settings, user’s name, and then My Documents
B. Browse to the root, Users, Documents and Settings, user’s name, and then My Documents
C. Type %system% into the run box
D. Type %temp% into the run box, My Documents, and then user’s name

[单项选择] A technician needs to troubleshoot connectivity between two devices located on the same network. Which of the following BEST describes the type of protocol being used?（）
A. IGP
B. EIGRP
C. EGP
D. BGP

[单项选择]A technician needs to change an existing drive formatted in FAT32 to a NTFS format, whileretaining the data. Which of the following is the BEST way to make this change?（）
A. Use Device Manager to disable the drive, then format it as NTFS.
B. Use Disk Management to change the format type.
C. Use Task Manager to start the CHKNTFS command.
D. Run the CONVERT command from the command prompt

[单项选择]A technician needs to assign a default subnet mask for a class B network to a network device that was just installed. Which of the following would the technician use?（）
A. 224.0.0.1
B. 255.0.0.0
C. 255.255.0.0
D. 255.255.255.0

[单项选择]A technician needs a wireless access point to cover most of the office. Which of the following should the technician perform FIRST to achieve this? （）
A. Change the radio channel
B. Apply MAC address filter
C. Determine placement
D. Reduce radio power level