更多"In a workgroup, all of the followin"的相关试题:
[单项选择]Which of the following steps in hypothesis testing most likely follows collecting the data and calculating the test statistic（）
A. Stating the decision rule.
B. Making the statistical decision.
C. Specifying the significance level.
[单项选择]Which of the following steps enables offline files in Windows 2000 and Windows XP?（）
A. Control Panel>Administrative Tools>Computer Management
B. Control Panel>Administrative Tools>Component Services
C. Windows Explorer>Tools>Folder Options>Offline Files
D. Windows Explorer>Tools>Synchronize>Setup
[多项选择]Which three of the following steps are mandatory when configuring MPLS on Cisco IOS? （）(Choose three.)
A. start LDP
B. enable CEF switching
C. configure the MPLS ID
D. disable IP TTL propagation
E. configure conditional label advertising
F. enable label switching on frame mode interfaces
[单项选择]Which of the following steps would be performed FIRST to install a fresh copy of Windows 7Professional on a new hard drive?（）
A. Format the partition
B. Load any RAID or SATA drivers needed
C. Partition the drive
D. Configure Windows settings
[多项选择]Which of the following steps are necessary in order to add a new VLAN to a switched network?（）
A. Create the VLAN.
B. Name the VLAN.
C. Configure an IP address for the VLAN.
D. Add the desired ports to the new VLAN.
E. Add the VLAN to the VTP domain.
[单项选择]Of the following steps, which occurs before the others in making a decision worksheet
A. Listing the consequences of each solution.
B. Calculating a numerical summary of each solution.
C. Deciding which consequences are most important.
D. Writing down all possible solutions.
[单项选择] Given the following steps, which would be the correct order to create a backup of an Oracle database in NOARCHIVELOG mode?（） 1.shutdown immediate from RMAN 2.Log into RMAN 3.startup mount from RMAN 4.backup database 5.alter database open 6.backup database plus archivelog delete input
A. 2，3，1，4，5
B. 2，1，3，6，5
C. 1，3，5，4
D. 2，1，3，5，6
E. 2，1，3，4，5
[单项选择]Which of the following disaster recovery sites requires power and cabling to be run before it can be used?（）
A. Hotsite
B. Coldsite
C. Warmsite
D. Failoversite
[单项选择]Which of the following troubleshooting steps should be performed NEXT after a core router hasbeen reported down?（）
A. Implement a solution.
B. Establish the outage cause.
C. Identify all affected areas.
D. Test a solution.
[单项选择]The following are all optimum conditions except
A. little sky cover.
B. higher temperature.
C. higher humidity.
D. lower temperature.
[单项选择]The following are all products imported by Australia from China EXCEPT
A. food.
B. textiles.
C. steel products.
D. electronics.
[单项选择]The following arc all used to attract passengers EXCEPT ______.
A. punctuality
B. sound system
C. free drinks
D. charge-free food
[单项选择]The following are all used to attract passengers EXCEPT ______.
A. punctuality
B. free drinks
C. headsets
D. charge-free food
[单项选择]The following events all require an SDCCH. Which event has normally the longest holding time? （）
A. Normal updating
B. IQMSI attach/detach
C. Registration
D. Call set-up
E. SMS point-to-point
[单项选择]Which of the following are all valid DB2 data types?（）
A. LONG VARCHAR, SMALLINT, NUMBER, BLOB
B. DECIMAL, DATE, DBCLOB, INTERVAL
C. NUMERIC, TIMESTAMP, BYTE, FLOAT
D. NUM, TIME, XML, DOUBLE
[单项选择]A workgroup switch is configured with all ports assigned to VLAN 2. In addition,all ports are configured as full-duplex FastEthernet. What is the effect of adding switch ports to a new VLAN on this switch?（）
A. The additions will create more collision domains.
B. IP address utilization will be more efficient.
C. More bandwidth will be required than was needed previously.
D. An additional broadcast domain will be created.
E. The possibility that switching loops will occur will increase dramatically.
[多项选择]Which of the following correctly describe steps in the OSI data encapsulation process?（）
A. The transport layer divides a data stream into segments and may add reliability and flow control information.
B. The data link layer adds physical source and destination addresses and an FCS to the segment.
C. Packets are created when the network layer encapsulates a frame with source and destination host addresses and protocol-related control information.
D. Packets are created when the network layer adds Layer 3 addresses and control information to a segment.
E. The presentation layer translates bits into voltages for transmission across the physical link.
