更多"A workgroup switch is configured wi"的相关试题:
[单项选择]A switch is configured with all ports assigned to vlan 2 with full duplex FastEthernet to segment existing departmental traffiC.What is the effect of adding switch ports to a new VLAN on the switch?()
A. More collision domains will be created.
B. IP address utilization will be more efficient.
C. More bandwidth will be required than was needed previously.
D. An additional broadcast domain will be created.
[多项选择]Switch ports operating in which two roles will forward traffic according to the IEEE 802.1w standard?()
A. alternate
B. backup
C. designated
D. disabled
E. root
[单项选择]In a workgroup, all of the following steps are required for a DHCP server EXCEPT().
A. activate the scopes.
B. authorize the server.
C. configure the scopes.
D. install DHCP service.
[单项选择]VLAN 3 is not yet configured on your switch. What happens if you set the switchport access vlan3 commmand interface configuration mode?()
A. The command is accepted and the respective VLAN is added to vlan dat.
B. The command is rejected.
C. The command is accepted and you must configure the VLAN manually.
D. The port turns amber.
[单项选择]VLAN 3 is not yet configured on your switch.What happens if you set the switchport access vlan 3 commmand interface configuration mode?()
A. The command is accepted and the respective VLAN is added to vlan dat.
B. The command is rejected.
C. The command is accepted and you must configure the VLAN manually.
D. The port turns amber.
[单项选择]When a new trunk is configured on a 2950 switch, which VLANs by default are allowed over the trunk link()。
A. no VLANs
B. all VLANs
C. only VLANs 1 - 64
D. only the VLANs that are specified when creating the trunk
[单项选择]A switch is configured as a vtp sever with a domain name of CCNA.Which cisco ios privileged mode command,followed by are load of the swith,will reset the VTP management domain name of the switch to a NULL value?()
A. #vtp domain unset
B. #delete vlan.dat
C. #novtp domain
D. #vtp domain null
[单项选择]Switch A is configured with VLAN 105 and 106. Switch Bis configured with VLAN 105 and 107.Both switches are connected with a fiber cable. In order for packets from all VLANs to cross thefiber cable, which of the following configurations MUST be present? ()
A. Reverse ARP
B. Full duplex on the fiber link
C. PoE
D. 802.1q trunking
[多项选择]Switch ports operating in which two roles will forward traffic according to the IEEE 802.1w standard?()
A. alternate
B. backup
C. designated
D. disabled
E. root
[单项选择]All lighterage in or off ports of loading or ports of discharge shall be for the account of ().
A. the carrier
B. the merchant
C. the owner
D. the shipper
[单项选择] Switch R1 has been configured with Private VLANs. With that type of PVLAN port should the default gateway be configured?()
A. Trunk
B. Isolated
C. Primary
D. Community
E. Promiscuous
F. None of the other alternatives apply