更多"[单选题]When ATT HDG and AIR DATA sel "的相关试题:
[单选题]ADR (Air Data Reference) can supplies:
A. A. Barometric altitude, airspeed, mach, angle of attack, temperature
B. B. Overspeed warnings
C. C. Both correct
[单选题]Which requirement below should be met when conducting a stabilized approach?
A.The rate of descent must less than 1500 ft/min above AGL 1000 ft
B.Stabilized thrust (usually above idle), glide slope established, maintain a target approach speed
C.glide slope established above AGL 500 feet
[单选题]Which act below is not correct when go around after encountering a windshear?
A.Increase two engine thrust lever to TOGA detent
B.Follow the flight instruction and monitor the flight parameter
C.Retract the landing gear
[单选题]When IR3 fault, which is correct:
A. A．AIR DATA sel in the F/O3 position
B. B．ATT HDG sel in the F/O3 position
C. C．ATT HDG sel in the NORM position
[单选题]When ENG FIRE pb is released. Which system will be closed
A. fuel，electrical，bleed
B. fuel，hydraulic，bleed
C. ，hydraulic，electrical ，bleed
[单选题]When SEAT BELT sw at AUTO, on which condition FASTEN SEAT BELT and RETURN TO SEAT sign come on simultaneously?
A. Flaps are extended at least 15°
B. The main landing gear is extended
C. Both correct
[单选题]When NO SMOKING sw at AUTO, on which condition EXIT signs come on?
A. Flaps are extended at least 15°
B. The landing gear is extended
C. Both correct
[单选题]When the N2 is below which value the FADEC run an abort sequence if a start aborts on the ground by closing the HP valve and start valve, turning off ignition and cranking the engine after the start abort in order to clear out fuel vapors?
A. < 43 %
B. < 50 %
C. < 59 %
[单选题]When α-floor conditions are met, which of the following indications are called up?
A.? “A FLOOR” in green, surrounded by a flashing amber box on the FMA
B. “A FLOOR” in amber on the engine warning display
C. Both A and B are correct
[单选题]HDG/TRK preset is available before takeoff and up to ____ ft.
A.30
B.40
C.50
[单选题] 在起飞前一直到多少英尺都可预调HDG/TRK？
A.30
B.40
C.50
[单选题]foo 对象有 att 属性，那么获取 att 属性的值，以下哪些做法是不可以的：（）
A.foo.att
B.foo(“att”)
C.foo*“att”+
D.foo*“a”+”t”+”t”+
[单选题]当MECH或ATT频道收到呼叫时，相应琥珀色字将闪亮，如未复位，MECH或ATT琥珀色灯将在______秒后熄灭
A.30
B.45
C.60
[单选题]在PFD上出现CHECK HDG（检查航向）故障旗（琥珀色）时，表示：
A.航向信息失效
B.机长和副驾驶的航向指示存在差异（5度）
C.飞机进入高纬度地区，需要转换成真航向
[单选题]起飞前转动HDG/TRK旋钮设置所需的航向/航迹，不正确的是：
A.NAV方式解除预位
B.在30英尺时FMA显示RWY TRK
C.到达增速高度时自动转换为HDG
D.按下旋钮重新接通NAV方式
[单选题] 如果航向值不一致至少多少度,两个PFD和ND均显示“CHECK HDG(检查航向)”信息？
A.5
B.4
C.3
[单选题]Model Sel功能的作用是 （ ）
A.反向通道
B.失控保护
C.模型切换
